40 CFR 86, Appendix XV to Part 86 - Procedure for Determining an Acceptable Exhaust Regeneration Durability-Data Test Schedule for Diesel Cycle Vehicles Equipped With Periodically Regenerating Trap Oxidizer Systems Certifying to the Provisions of Part 86,

EPA and NHTSA, on behalf of the Department of Transportation, are issuing final rules to further reduce greenhouse gas emissions and improve fuel economy for light-duty vehicles for model years 2017 and beyond. On May 21, 2010, President Obama issued a Presidential Memorandum requesting that NHTSA and EPA develop through notice and comment rulemaking a coordinated National Program to improve fuel economy and reduce greenhouse gas emissions of light-duty vehicles for model years 2017-2025, building on the success of the first phase of the National Program for these vehicles for model years 2012-2016. This final rule, consistent with the President's request, responds to the country's critical need to address global climate change and to reduce oil consumption. NHTSA is finalizing Corporate Average Fuel Economy standards for model years 2017-2021 and issuing augural standards for model years 2022-2025 under the Energy Policy and Conservation Act, as amended by the Energy Independence and Security Act. NHTSA will set final standards for model years 2022-2025 in a future rulemaking. EPA is finalizing greenhouse gas emissions standards for model years 2017-2025 under the Clean Air Act. These standards apply to passenger cars, light-duty trucks, and medium-duty passenger vehicles, and represent the continuation of a harmonized and consistent National Program. Under the National Program automobile manufacturers will be able to continue building a single light-duty national fleet that satisfies all requirements under both programs while ensuring that consumers still have a full range of vehicle choices that are available today. EPA is also finalizing minor changes to the regulations applicable to model years 2012-2016, with respect to air conditioner performance, nitrous oxides measurement, off-cycle technology credits, and police and emergency vehicles.

EPA is taking final action to establish nonconformance penalties (NCPs) for manufacturers of heavy heavy-duty diesel engines (HHDDE) in model years 2012 and later for emissions of oxides of nitrogen (NO X ) because we have found the criteria for NCPs and the Clean Air Act have been met. The NO X standards to which these NCPs apply were established by a rule published on January 18, 2001. In general, NCPs allow a manufacturer of heavy-duty engines (HDEs) whose engines do not conform to applicable emission standards, but do not exceed a designated upper limit, to be issued a certificate of conformity upon payment of a monetary penalty to the United States Government. The upper limit associated with these NCPs is 0.50 grams of NO X per brake horsepower-hour (g/bhp-hr). This Final Rule specifies certain parameters that are entered into the preexisting penalty formulas along with the emissions of the engine and the incorporation of other factors to determine the amount a manufacturer must pay. Key parameters that determine the NCP a manufacturer must pay are EPA's estimated cost of compliance for a near worst-case engine and the degree to which the engine exceeds the emission standard (as measured from production engines). EPA proposed NCPs for medium heavy duty diesel engines. However, EPA is not taking final action with regard to NCPs for these engines at this time because EPA has not completed its review of the data and comments regarding these engines.

The Environmental Protection Agency (EPA or Agency) is denying the petition of Plant Oil Powered Diesel Fuel Systems, Inc. (“POP Diesel”) to reconsider the final rules establishing emissions standards to reduce greenhouse gas emissions from on-road heavy-duty vehicles.

This notice announces that EPA will review three regulatory actions pursuant to section 610 of the Regulatory Flexibility Act. Those three actions are: Heavy-Duty Engine and Vehicle Standards and Highway Diesel Fuel Sulfur Control Requirements (Heavy-Duty 610 Review); NESHAP: Reinforced Plastic Composites Production (Plastics 610 Review); and NPDES Permit Regulation and Effluent Limitations Guidelines Standards for CAFOs (CAFO 610 Review). As part of this review, EPA will consider and solicit comments on the following factors: The continued need for the rules; the nature of complaints or comments received concerning the rules; the complexity of the rules; the extent to which the rules overlap, duplicate, or conflict with other Federal, State, or local government rules; and the degree to which the technology, economic conditions or other factors have changed in areas affected by the rules.

EPA and NHTSA, on behalf of the Department of Transportation, are issuing final rules to further reduce greenhouse gas emissions and improve fuel economy for light-duty vehicles for model years 2017 and beyond. On May 21, 2010, President Obama issued a Presidential Memorandum requesting that NHTSA and EPA develop through notice and comment rulemaking a coordinated National Program to improve fuel economy and reduce greenhouse gas emissions of light-duty vehicles for model years 2017-2025, building on the success of the first phase of the National Program for these vehicles for model years 2012-2016. This final rule, consistent with the President's request, responds to the country's critical need to address global climate change and to reduce oil consumption. NHTSA is finalizing Corporate Average Fuel Economy standards for model years 2017-2021 and issuing augural standards for model years 2022-2025 under the Energy Policy and Conservation Act, as amended by the Energy Independence and Security Act. NHTSA will set final standards for model years 2022-2025 in a future rulemaking. EPA is finalizing greenhouse gas emissions standards for model years 2017-2025 under the Clean Air Act. These standards apply to passenger cars, light-duty trucks, and medium-duty passenger vehicles, and represent the continuation of a harmonized and consistent National Program. Under the National Program automobile manufacturers will be able to continue building a single light-duty national fleet that satisfies all requirements under both programs while ensuring that consumers still have a full range of vehicle choices that are available today. EPA is also finalizing minor changes to the regulations applicable to model years 2012-2016, with respect to air conditioner performance, nitrous oxides measurement, off-cycle technology credits, and police and emergency vehicles.

EPA is taking final action to establish nonconformance penalties (NCPs) for manufacturers of heavy heavy-duty diesel engines (HHDDE) in model years 2012 and later for emissions of oxides of nitrogen (NO X ) because we have found the criteria for NCPs and the Clean Air Act have been met. The NO X standards to which these NCPs apply were established by a rule published on January 18, 2001. In general, NCPs allow a manufacturer of heavy-duty engines (HDEs) whose engines do not conform to applicable emission standards, but do not exceed a designated upper limit, to be issued a certificate of conformity upon payment of a monetary penalty to the United States Government. The upper limit associated with these NCPs is 0.50 grams of NO X per brake horsepower-hour (g/bhp-hr). This Final Rule specifies certain parameters that are entered into the preexisting penalty formulas along with the emissions of the engine and the incorporation of other factors to determine the amount a manufacturer must pay. Key parameters that determine the NCP a manufacturer must pay are EPA's estimated cost of compliance for a near worst-case engine and the degree to which the engine exceeds the emission standard (as measured from production engines). EPA proposed NCPs for medium heavy duty diesel engines. However, EPA is not taking final action with regard to NCPs for these engines at this time because EPA has not completed its review of the data and comments regarding these engines.

The Environmental Protection Agency (EPA or Agency) is denying the petition of Plant Oil Powered Diesel Fuel Systems, Inc. (“POP Diesel”) to reconsider the final rules establishing emissions standards to reduce greenhouse gas emissions from on-road heavy-duty vehicles.