47 CFR 73.128 - AM stereophonic broadcasting.

Status message

There are 46 Updates appearing in the Federal Register for 47 CFR 73. View below or at eCFR (GPOAccess)
§ 73.128 AM stereophonic broadcasting.
(a) An Am broadcast station may, without specific authority from the FCC, transmit stereophonic programs upon installation of type accepted stereophonic transmitting equipment and the necessary measuring equipment to determine that the stereophonic transmissions conform to the modulation characteristics specified in paragraphs (b) and (c) of this section. Stations transmitting stereophonic programs prior to March 21, 1994 may continue to do so until March 21, 1995 as long as they continue to comply with the rules in effect prior to March 21, 1994.
(b) The following limitations on the transmitted wave must be met to insure compliance with the occupied bandwidth limitations, compatibility with AM receivers using envelope detectors, and any applicable international agreements to which the FCC is a party:
(1) The transmitted wave must meet the occupied bandwidth specifications of § 73.44 under all possible conditions of program modulation. Compliance with requirement shall be demonstrated either by the following specific modulation tests or other documented test procedures that are to be fully described in the application for type acceptance and the transmitting equipment instruction manual. (See § 2.983(d)(8) and (j)).
(i) Main channel (L R) under all conditions of amplitude modulations for the stereophonic system but not exceeding amplitude modulation on negative peaks of 100%.
(ii) Stereophonic (L−R) modulated with audio tones of the same amplitude at the transmitter input terminals as in paragraph (b)(i) of this section but with the phase of either the L or R channel reversed.
(iii) Left and Right Channel only, under all conditions of modulation for the stereophonic system in use but not exceeding amplitude modulation on negative peaks of 100%.
(c) Effective on December 20, 1994, stereophonic transmissions shall conform to the following additional modulation characteristics:
(1) The audio response of the main (L R) channel shall conform to the requirements of the ANSI/EIA-549-1988, NRSC-1 AM Preemphasis/Deemphasis and Broadcast Transmission Bandwidth Specifications (NRSC-1).
(2) The left and right channel audio signals shall conform to frequency response limitations dictated by ANSI/EIA-549-1988.
(3) The stereophonic difference (L−R) information shall be transmitted by varying the phase of the carrier in accordance with the following relationship:
where:
L(t)=audio signal left channel,
R(t)=audio signal right channel,
m=modulation factor, and
mpeak(L(t) R(t))=1 for 100% amplitude modulation,
mpeak(L(t)−R(t))=1 for 100% phase modulation.
(4) The carrier phase shall advance in a positive direction when a left channel signal causes the transmitter envelope to be modulated in a positive direction. The carrier phase shall likewise retard (negative phase change) when a right channel signal causes the transmitter envelope to be modulated in a positive direction. The phase modulation shall be symmetrical for the condition of difference (L−R) channel information sent without the presence of envelope modulation.
(5) Maximum angular modulation, which occurs on negative peaks of the left or right channel with no signal present on the opposite channel (L(t)=−0.75, R(t)=0, or R(t)=−0.75, L(t)=0) shall not exceed 1.25 radians.
(6) A peak phase modulation of /−0.785 radians under the condition of difference (L−R) channel modulation and the absence of envelope (L R) modulation and pilot signal shall represent 100% modulation of the difference channel.
(7) The composite signal shall contain a pilot tone for indication of the presence of stereophonic information. The pilot tone shall consist of a 25 Hz tone, with 3% or less total harmonic distortion and a frequency tolerance of /− 0.1 H2, which modulates the carrier phase /− 0.05 radians peak, corresponding to 5% L−R modulation when no other modulation is present. The injection level shall be 5%, with a tolerance of 1, −1%.
(8) The composite signal shall be described by the following expression:
where:
A=the unmodulated carrier voltage
m=the modulation index
Csn=the magnitude of the nth term of the sum signal
Cdn=the magnitude of the nth term of the difference signal
ωsn=the nth order angular velocity of the sum signal
ωdn=the nth order angular velocity of the difference signal
ωc=the angular velocity of the carrier
Asn and Bsn are the nth sine and cosine coefficients of Csn
Adn and Bdn are the nth sine and cosine coefficients of Cdn
[58 FR 66301, Dec. 20, 1993]

Title 47 published on 2013-10-01

The following are only the Rules published in the Federal Register after the published date of Title 47.

For a complete list of all Rules, Proposed Rules, and Notices view the Rulemaking tab.

  • 2014-11-21; vol. 79 # 225 - Friday, November 21, 2014
    1. 79 FR 69375 - Radio Broadcasting Services; Various Locations
      GPO FDSys XML | Text
      FEDERAL COMMUNICATIONS COMMISSION
      Final rule.
      Effective November 21, 2014.
      47 CFR Part 73

This is a list of United States Code sections, Statutes at Large, Public Laws, and Presidential Documents, which provide rulemaking authority for this CFR Part.

This list is taken from the Parallel Table of Authorities and Rules provided by GPO [Government Printing Office].

It is not guaranteed to be accurate or up-to-date, though we do refresh the database weekly. More limitations on accuracy are described at the GPO site.


United States Code

Title 47 published on 2013-10-01

The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 47 CFR 73 after this date.

  • 2014-11-21; vol. 79 # 225 - Friday, November 21, 2014
    1. 79 FR 69375 - Radio Broadcasting Services; Various Locations
      GPO FDSys XML | Text
      FEDERAL COMMUNICATIONS COMMISSION
      Final rule.
      Effective November 21, 2014.
      47 CFR Part 73