49 CFR 178.358-5 - Required markings.
(a) Markings must be as prescribed in § 178.3.
(b) Specification marking on the outside of each overpack must be as follows: “USA-DOT-21PF-1”, “1A”, “1B”, or “2”, as appropriate.
(1) For Specifications 21PF-1 and 21PF-2 only, if the inner shell is constructed of stainless steel, additional marking such as “304L-SS” are to be marked on the outside of the overpack to indicate the type of stainless steel used.
(2) For Specification 21PF-1 and 21PF-2 only, “TARE WT: * * * lbs. (* * * kg)” where * * * is the tare weight in pounds and kilograms, respectively, of the assembled overpack without the inner product container.
(3) For Specification 21PF-1A and 21PF-1B only: “TARE WT. of Cover: * * * lbs (* * * kg) TARE WT. of BOTTOM: * * * lbs (* * * kg)” where * * * is the tare weight in pounds and kilograms, respectively, of the separate halves of the overpack without the inner product container. For Specification 21PF-1A overpacks, the previous tare weight must be changed to reflect the modified tare weight value or must be covered or removed.
(5) The name or symbol of maker or party certifying compliance with specification requirements. A symbol, if used, must be registered with the Associate Administrator.
(c) For Specification 21PF-1A and -1B only, the markings required by this section must be affixed to each overpack by inscription upon a metal identification plate 11 inches wide × 15 inches long (28 cm × 38 cm), fabricated of 16 to 20 gauge stainless steel sheet, ASTM A-240/A 240M (IBR, see§ 171.7 of this subchapter), Type 304L.
Title 49 published on 2014-10-01
no entries appear in the Federal Register after this date.