10 CFR Appendix V to Subpart B of Part 430 - Appendix V to Subpart B of Part 430—Uniform Test Method for Measuring the Energy Consumption of Ceiling Fan Light Kits Packaged With Other Fluorescent Lamps (Not Compact Fluorescent Lamps or General Service Fluorescent Lamps), Packaged With Consumer-Replaceable SSL (Not Integrated LED Lamps), Packaged With Non-Consumer-Replaceable SSL, or Packaged With Other SSL Lamps That Have an ANSI Standard Base (Not Integrated LED Lamps)

Appendix V to Subpart B of Part 430—Uniform Test Method for Measuring the Energy Consumption of Ceiling Fan Light Kits Packaged With Other Fluorescent Lamps (Not Compact Fluorescent Lamps or General Service Fluorescent Lamps), Packaged With Consumer-Replaceable SSL (Not Integrated LED Lamps), Packaged With Non-Consumer-Replaceable SSL, or Packaged With Other SSL Lamps That Have an ANSI Standard Base (Not Integrated LED Lamps)
Note:

Manufacturers must use the results of testing under this appendix to determine compliance with the relevant standards for ceiling fan light kits as those standards appeared in January 1, 2023 edition of 10 CFR parts 200499. Specifically, before October 10, 2023 representations must be based upon results generated either under this appendix as codified on May 11, 2023 or under appendix V1 as it appeared in the 10 CFR parts 200499 edition revised as of January 1, 2023. Any representations made on or after October 10, 2023 must be made based upon results generated using this appendix as codified on May 11, 2023.

0. Incorporation by Reference.

DOE incorporated by reference in § 430.3 the entire standard for: IES LM–9–20, IES LM–54–20, IES LM–75–19, IES LM–78–20, and IES LM–79–19; however, only enumerated provisions of IES LM–9–20 and IES LM–79–19 are applicable to this appendix as follows:

0.1 IES LM–9–20 as referenced by section 3 of this appendix

(a) Section 4.0 “Ambient and Physical Conditions”.

(b) Section 5.0 “Electrical Conditions”.

(c) Section 6.0 “Lamp Test Procedures”.

(d) Section 7.0 “Photometric Test Procedures”.0.2 IES LM–79–19 as referenced by section 3 of this appendix

(a) Section 4.0 “Physical and Environmental Test Conditions”.

(b) Section 5.0 “Electrical Test Conditions”.

(c) Section 6.0 “Test Preparation”.

(d) Section 7.0 “Total Luminous Flux and Integrated Optical Measurements”.

1. Scope

This appendix establishes the test requirements to measure the energy efficiency of all ceiling fan light kits (CFLKs) packaged with fluorescent lamps other than compact fluorescent lamps (CFLs) or general service fluorescent lamps (GSFLs), packaged with consumer-replaceable solid-state lighting (SSL) (not integrated light-emitting diode [LED] lamps), packaged with non-consumer-replaceable SSL, or packaged with SSL lamps that have an American National Standards Institute (ANSI) standard base (not integrated LED lamps).

2. Definitions

2.1. CFLK with non-consumer-replaceable SSL means a CFLK with a non-ANSI-standard base that has an SSL light source, driver, heat sink, and intermediate circuitry (such as wiring between a driver and a light source) that are not consumer replaceable, i.e., a consumer cannot replace the light source and all components necessary for the starting and stable operation of the light source, without permanently altering the product and must replace the entire CFLK upon failure. Permanently altering the product constitutes the cutting of wires, use of a soldering iron, or damage to or destruction of the CFLK and does not constitute connecting or disconnecting wire nuts, fasteners or screws, or preserving the CFLK as it was sold.

2.2. CFLK with consumer-replaceable SSL means a CFLK with a non-ANSI-standard base that has an SSL light source, driver, heat sink, and intermediate circuitry (such as wiring between a driver and light source) that are consumer replaceable, i.e., a consumer can replace the light source and all components necessary for the starting and stable operation of the light source, without permanently altering the product. Permanently altering the product constitutes the cutting of wires, use of a soldering iron, or damage to or destruction of the CFLK and does not constitute connecting or disconnecting wire nuts, fasteners or screws, or preserving the CFLK as it was sold.

2.3. Covers means materials used to diffuse or redirect light produced by an SSL light source in CFLKs with non-consumer-replaceable SSL.

2.4. Other (non-CFL and non-GSFL) fluorescent lamp means a low-pressure mercury electric-discharge lamp in which a fluorescing coating transforms some of the ultraviolet energy generated by the mercury discharge into light, including but not limited to circline fluorescent lamps, and excluding any compact fluorescent lamp and any general service fluorescent lamp.

2.5. Solid-State Lighting (SSL) means technology where light is emitted from a solid object—a block of semiconductor—rather than from a filament or plasma, as in the case of incandescent and fluorescent lighting. This includes inorganic light-emitting diodes (LEDs) and organic light-emitting diodes (OLEDs).

3. Test Conditions and Measurements

For any CFLK that utilizes consumer replaceable lamps or consumer-replaceable SSL, measure the lamp efficacy of each basic model of lamp or SSL light source packaged with the CFLK. For any CFLK only with non-consumer-replaceable SSL, measure the luminaire efficacy of the CFLK. For any CFLK that includes consumer replaceable lamps or consumer-replaceable SSL and non-consumer-replaceable SSL, measure both the lamp efficacy of each basic model of lamp or consumer-replaceable SSL light source packaged with the CFLK and the luminaire efficacy of the CFLK with all consumer replaceable lamps or consumer-replaceable SSL light sources removed. Take measurements at full light output. For each test, use the test procedures in the table in this section. CFLKs with non-consumer-replaceable SSL and consumer replaceable covers may be measured with their covers removed but must otherwise be measured according to the table in this section.

Lighting technology Lamp or luminaire efficacy measured Referenced test procedure
Other (non-CFL and non-GSFL) fluorescent lamps Lamp Efficacy IES LM–9–20, sections 4–7 and corresponding subsections including references to IES LM–54–20 (lamp seasoning); IES–LM–78–20 (integrating sphere measurements).
CFLKs with consumer-replaceable SSL Lamp Efficacy IES LM–79–19, sections 4–7 and corresponding subsections. Where IES LM–78–17 and IES LM–75–01/R12 are referenced in these sections and corresponding subsections, use IES LM–78–20 (integrating sphere measurements) and IES LM–75–19 (goniophotometer measurements) instead.
CFLKs with non-consumer-replaceable SSL Luminaire Efficacy IES LM–79–19, sections 4–7 and corresponding subsections. Where IES LM–78–17 and IES LM–75–01/R12 are referenced in these sections and corresponding subsections, use IES LM–78–20 (integrating sphere measurements) and IES LM–75–19 (goniophotometer measurements) instead.
Other SSL lamps that have an ANSI standard base and are not integrated LED lamps Lamp Efficacy IES LM–79–19, sections 4–7 and corresponding subsections. Where IES LM–78–17 and IES LM–75–01/R12 are referenced in these sections and corresponding, use IES LM–78–20 (integrating sphere measurements) and IES LM–75–19 (goniophotometer measurements) instead.
[88 FR 21073, Apr. 10, 2023]