40 CFR 63.7915 - What emissions limitations and work practice standards must I meet for transfer systems?
(a) You must control HAP emissions from each new and existing transfer system subject to § 63.7886(b)(1)(v) according to emissions limitations and work practice standards in this section that apply to your affected transfer systems.
(c) For each affected transfer system that is not an individual drain system as defined in § 63.7957, you must use one of the transfer systems specified in paragraphs (c)(1) through (3) of this section.
(2) A transfer system that consists of continuous hard piping. All joints or seams between the pipe sections must be permanently or semi-permanently sealed (e.g., a welded joint between two sections of metal pipe or a bolted and gasketed flange).
(i) The transfer system is designed and operated such that an internal pressure in the vapor headspace in the enclosure is maintained at a level less than atmospheric pressure when the control device is operating, and
(ii) The closed vent system and control device are designed and operated to meet the emissions limitations and work practice standards in § 63.7925 that apply to your closed vent system and control device.
(d) As provided in § 63.6(g), you may request approval from the EPA to use an alternative to the work practice standards in this section that apply to your transfer systems. If you request for permission to use an alternative to the work practice standards, you must submit the information described in § 63.6(g)(2).
- 40 CFR 63.7886 — What Are the General Standards I Must Meet for My Affected Remediation Material Management Units?
- 40 CFR 63.7918 — How Do I Demonstrate Continuous Compliance With the Emissions Limitations and Work Practice Standards for Transfer Systems?
- 40 CFR 63.7917 — What Are My Inspection and Monitoring Requirements for Transfer Systems?
- 40 CFR 63.7916 — How Do I Demonstrate Initial Compliance With the Emissions Limitations and Work Practice Standards for Transfer Systems?