7 CFR § 3560.103 - Maintaining housing projects.
(a) Physical maintenance.
(1) The purposes of physical maintenance are the following:
(i) Provide decent, safe, and sanitary housing; and
(ii) Maintain the security of the property.
(2) Borrowers are responsible for the long-term, cost-effective preservation of the housing project.
(3) At all times, borrowers must maintain housing projects in compliance with local, state and federal laws and regulations and according to the following Agency requirements for affordable, decent, safe, and sanitary housing. Agency design requirements are discussed in § 3560.60. The Agency acknowledges that property maintenance is an ongoing process and will not penalize borrowers for less than 100 percent compliance as long as it is evident that the borrower is striving to achieve the standards listed in this paragraph. In addition, the Agency understands that although its multifamily housing portfolio is relatively homogeneous, no one standard is appropriate for all properties.
(i) Utilities. The housing project must have an adequate and safe water supply, a functional and safe waste disposal system, and must be free of hazardous waste material.
(ii) Drainage and erosion control. The housing project must have drainage that effectively protects the housing project from water damage from standing water and erosion. Units, basements, and crawl spaces must be free of water seepage.
(iii) Landscaping and grounds. The housing project must be landscaped attractively. Lawns, plants and shrubs must be maintained and must allow air to windows, vents, and sills. Recreation areas must be maintained in a safe and clean manner and trash collection areas must be adequately sized, screened, and maintained.
(iv) Drives, parking services and walks. The housing project must have drives, parking lots, and walks that are free of holes and deterioration. Walks with changes in height between slabs of approximately 1/2 inch or greater will be considered unacceptable.
(v) Exterior signage. All signs at the housing project, including those related to the housing project name, buildings, parking spaces, unit numbers and other informational directions must be visible and well-kept. Sign requirements must conform to § 3560.104(d).
(vi) Fences and retaining walls. The housing project must have fence lines that are free of trash, weeds, vines, and other vegetation. Fences must be free of holes and damaged or loose sections. The bases of all retaining walls must be erosion free and drainage weep holes must be cleaned out to prevent excessive pressure behind the retaining wall.
(vii) Debris and graffiti. The housing project, including common areas, must be free of trash, litter, and debris. Public walkways, walls of buildings and common areas must be free of graffiti.
(viii) Lighting. The housing project must have functional exterior lighting and functional interior lighting in common areas which permits safe access and security.
(ix) Foundation. The housing project must have a foundation that is free of evidence of structural failure, such as uneven settlement indicated by horizontal cracks or severe bowing of the foundation wall. Structural members must not have evidence of rot or insect or rodent infestation.
(x) Exterior walls and siding. The housing project must have walls that are free from deterioration which allows elements to infiltrate the structure, eaves, gables, and window trim that are free from deterioration, exterior wall coverings that are intact, securely attached, and in good condition. Brick veneers must be free of missing mortar or bricks.
(xi) Roofs, flashing, and gutters. The housing project must have gutters and downspouts, where appropriate for climatic conditions, that are securely attached, clean, and finished or painted properly with splash blocks or extenders that direct water flow away from the building. The housing project must have a roof that is free of leaks, defective covering, curled or missing shingles and which is not sagging or buckling. Fascia and soffits must be intact.
(xii) Windows, doors, and exterior structures. The housing project must have screens that are free of tears, breaks and rips and windows that are unbroken. Window thermopane seals must be unbroken and caulking on the exterior of windows and doors must be continuous and free of cracks. Doors must be weather tight, free of holes, and provide security with functional locks. Porches, balconies, and exterior stairs must be free of broken, missing, or rotting components.
(xiii) Common area accessibility. The housing project must have accessible, designated handicapped parking spaces with handicapped space signs properly posted. Common areas must be accessible through walks, ramps, porches, and thresholds. The laundry room must have accessible appliances and mailboxes must be at an accessible level. Elevators or mechanical lifts must be functional and kept in good repair.
(xiv) Common area signage. The following must be posted in a conspicuous place in a common area: “Justice for All” poster, HUD equal housing opportunity poster including the Spanish version if there are Hispanic Limited English Proficiency tenants or applicants, current affirmative fair housing marketing plan, the tenant grievance and appeal procedure, housing project occupancy rules, office hours and phone number, and emergency hours and phone number.
(xv) Flooring. If a housing project has carpeting, the carpet must be clean, without excessive wear, and seams that are secure and stretched properly. If the housing project has resilient flooring, the flooring must be clean, unstained, free of tears and breaks, and seams that are secure.
(xvi) Walls, floors, and ceilings. The housing project must have walls, floors, and ceilings that are free of holes, evidence of current water leaks, and free of material that appears in danger of falling. The housing project must have wallboard joints that are secure and free of cracks.
(xvii) Doors and windows. The housing project must have doors that are free of holes, secure, unbroken and easily operable hardware, deadbolt locks which are in place and secure, and, if doors are metal, free of rust. The housing project must have windows which are easily operated, free of bent blinds or torn curtains, and window interiors must be free of evidence of moisture damage.
(xviii) Electrical, air conditioning and heating. The housing project must have heating and cooling units that are free of bare wires and which are functioning properly, including thermostats. The housing project must not have uncovered outlets or other evident safety hazards, switches which work improperly, or light fixtures which are broken and inoperable.
(xix) Water heaters. The housing project must have water heaters which are operating properly, free of leaks, supply adequate hot water, and are fitted with temperature and pressure relief valves.
(xx) Smoke alarms. The housing project must have smoke alarms which are properly located according to local code and which operate properly.
(xxi) Emergency call system. If a housing project has an emergency call system, the switches must be located in the bathroom and bedroom, furnished with a pull cord, with the down position set to “ON”, and must operate properly.
(xxii) Insect or vermin infestation. The housing project must have all units free of visible signs of insects or rodents and must be free of signs of insect or rodent damage.
(xxiii) Range and range hood. The housing project must have range units in which all elements are operable, electrical connections are secure and insulated, doors and drawers which are secure, control knobs and handles which are in place and secure, and housing which is sound and the finish is free of chips, damage, or signs of rust. The range hood fan and light must be operable.
(xxiv) Refrigerator. The housing project must have refrigerators in which the cooler and freezer are operating properly, the shelves and door containers are secure and free of rust, door gaskets are in good condition and functioning properly, and the housing is sound and the finish is free of chips, damage, or signs of rust.
(xxv) Sinks. The housing project must have sinks in which the fittings work properly and are free of leaks, plumbing connections under the cabinet which are free of leaks, the finish is free of chips, damage, or signs of rust, the strainer is in good condition and in place, and which are secured to a wall, counter, or vanity top.
(xxvi) Cabinets. The housing project must have cabinets and vanities which are secure to walls or floor and have faces, doors, and drawer fronts that are in good condition and free of breaks and peeling. Shelving must be in place, fastened securely, and free of warps. The housing project must have counter tops which are secure and free of burn marks or chips, bottoms under sinks which are free of evidence of warping, breaks, or being water soaked. Kitchen counter, vanity tops, and back splashes must be properly caulked.
(xxvii) Water closets. The housing project must have the base of the water closets at the floor properly caulked. The tanks must be free of cracks or leaks and have a lid which fits and is in good condition. The seats must be secure and in good condition, and the flushing mechanisms must be in good condition and operating properly. The stools must be free of cracks and breaks and be securely fastened to the floor.
(xviii) Bathtub and shower stalls. The housing project must have tubs or shower stalls which are free of cracks, breaks, and leaks, and a strainer in good condition and in place. The housing project must have walls and floors of the bathtubs which are properly caulked, tops and sides of shower stalls must be properly caulked, and the finish is free of chips, damage, or signs of rust.
(4) The Agency expects that upon discovery of a condition not in compliance with the standards listed in this section that the borrower will remedy the situation in a timeframe required by the Agency. The Borrower must provide documentation and justification for any failure to meet such timeframe. Properties with deficiencies in the process of being addressed will not be deemed to be out of compliance unless there are so many deficiencies that it would result in a declaration of substantial noncompliance and call into questions the viability of the property and the effectiveness of the borrower's maintenance program. Failure to make such corrections or repairs constitutes a non-monetary default under § 3560.452(e).
(b) Maintenance systems. Borrowers must establish the following maintenance systems and must describe these systems in their management plan.
(1) A system for routine maintenance, including:
(i) Regular maintenance tasks that can be prescheduled or planned; and
(ii) Tasks performed on a regular basis to maintain compliance with the standards established in paragraph (a)(3) of this section.
(2) A system for responsive maintenance including:
(i) A process for responding to requests for maintenance from tenants;
(ii) A process for responding to unexpected malfunctions of equipment or damages to building systems such as a furnace breakdown or a water leak; and
(iii) A “work order” process for managing and tracking responses to maintenance requests and the performance of maintenance tasks.
(3) A system for preventive maintenance including:
(i) Maintenance of mechanical systems, building exteriors, elevators, and heating and cooling systems which require specially trained personnel; and
(ii) Maintenance that supports energy-efficient operation of the housing project.
(4) A system for correcting deficiencies identified by periodic inspections, which must include:
(i) A move-in inspection;
(ii) A move-out inspection; and
(iii) An annual inspection of occupied units.
(c) Capital budgeting and planning.
(1) Borrowers must develop a capital budget as part of their annual housing project budget required under § 3560.303. The capital budget must include anticipated expenditures on the long-term capital needs of the housing project to assure adequate maintenance and replacement of capital items.
(2) If the borrower requests an increase in the project's reserve for replacement account, the borrower must have a capital needs assessment prepared and submitted to the Agency to reflect anticipated needs of the housing project for replacement of capital equipment and systems. The cost for preparation of a capital needs assessment will be approved by the Agency as an eligible housing project expense provided the capital needs assessment is reasonable in cost and meets Agency requirements.
(3) [Reserved]
(4) As a part of the annual budget process, borrowers may request an increase in the amount to be contributed and held in the housing project reserve account to fund the needs identified in an Agency-approved capital needs assessment.
(5) At any time, borrowers may request and the Agency may approve amendments to loan or grant documents to increase the amount of funds to be contributed and held in a reserve account to cover the cost of capital improvements based on the needs identified in an Agency approved capital needs assessment. Borrowers must assure improvements are performed as specified in the capital needs assessment.