Minimum sorbent injection rate

Minimum sorbent injection rate means:
(1) The load fraction multiplied by the lowest hourly average sorbent injection rate for each sorbent measured according to Table 7 to this subpart during the most recent performance test demonstrating compliance with the applicable emission limits; or
(2) For fluidized bed combustion not using an acid gas wet scrubber or dry sorbent injection control technology to comply with the HCl emission limit, the lowest average ratio of sorbent to sulfur measured during the most recent performance test.

Source

40 CFR § 63.7575

---

Scoping language

Terms used in this subpart are defined in the Clean Air Act, in 63.2 (the General Provisions), and in this section as follows:

---

Is this correct? or