Nondiscrimination requirement

(iii) Nondiscrimination requirement. The requirement of this paragraph (d)(8)(iii) is satisfied only if at least one of the following tests in paragraphs (d)(8)(iii) (A) through (D) of this section is satisfied. (A) Minimum percentage test. This test is satisfied only if more than 50 percent of the nonhighly compensated employees in the plan have average annual compensation at least equal to 120 percent of the integration or offset level. (B) Ratio test. This test is satisfied only if the percentage of nonhighly compensated nonexcludable employees, who are in the plan and who have average annual compensation at least equal to 120 percent of the integration or offset level, is at least 70 percent of the percentage of highly compensated nonexcludable employees who are employees in the plan. (C) High dollar amount test. This test is satisfied only if the integration or offset level exceeds 150 percent of the covered compensation of an individual who attains social security retirement age in the calendar year in which the plan year begins. In the case of a calendar year in which no individual could attain social security retirement age, for example, the year 2003, this rule is applied using covered compensation of an individual attaining social security retirement age in the preceding calendar year. (D) Individual disparity reductions. This test is satisfied only if the plan is an offset plan that uses an offset level of each employee's final average compensation and makes individual disparity reductions as permitted under paragraph (d)(9)(iii)(B) of this section. (9) Reduction in the 0.75-percent factor if integration or offset level exceeds covered compensation(i) In general. If the integration or offset level specified under the plan is each employee's covered compensation as of the plan year, no reduction in the 0.75-percent factor in the maximum excess or offset allowance is required for the plan year under this paragraph (d)(9). If a plan specifies an integration or offset level that exceeds an employee's covered compensation, the 0.75-percent factor in the maximum excess or offset allowance must be reduced as required in paragraph (d)(9)(ii) or (iii) of this section. Paragraph (d)(9)(iv) of this section contains a table of the applicable reductions. (ii) Uniform percentage of covered compensation. If a plan specifies an integration or offset level that is a uniform percentage (in excess of 100 percent) of each employee's covered compensation, the 0.75-percent factor in the maximum excess or offset allowance must be reduced in accordance with the table in paragraph (d)(9)(iv) of this section. Thus, for example, if a plan specifies an integration or offset level of 120 percent of each employee's covered compensation, the 0.75-percent factor in the maximum excess or offset allowance must be reduced to 0.69 percent in accordance with the table because the specified integration or offset level is more than covered compensation but not more than 125 percent of covered compensation. (iii) Single dollar amount. If a plan specifies an integration or offset level of a single dollar amount as permitted under paragraph (d)(5) of this section (for example, $30,000), the applicable reduction in the maximum excess or offset allowance must be determined under paragraph (d)(9)(iii) (A) or (B) of this section, as specified under the plan. (A) Plan-wide reduction. The applicable reduction in the maximum excess or offset allowance under the table in paragraph (d)(9)(iv) of this section may be determined by comparing the single dollar amount specified in the plan to the covered compensation of an individual attaining social security retirement age in the calendar year in which the plan year begins. Thus, for example, if a plan specifies a single integration or offset level of $30,000 that is uniformly applicable to all employees for a plan year and the covered compensation of an individual attaining social security retirement age in the calendar year in which the plan year begins is $20,000, the 0.75-percent factor in the maximum excess or offset allowance must be reduced to 0.60 percent for all employees in accordance with the table in paragraph (d)(9)(iv) of this section because the specified integration or offset level of $30,000 is more than 125 percent of $20,000 but not more than 150 percent of $20,000. In the case of a calendar year in which no individual could attain social security retirement age (for example, 2003), the comparison is made with covered compensation of an individual who attained social security retirement age in the preceding calendar year. If an offset plan uses an offset level of each employee's final average compensation, the reduction under this paragraph (d)(9)(iii)(A) is determined by comparing the highest possible amount of final average compensation to the covered compensation of an individual attaining social security retirement age in the calendar year in which the plan year begins. (B) Individual reductions. The applicable reduction in the maximum excess or offset allowance under the table in paragraph (d)(9)(iv) of this section may be determined by comparing the single dollar amount specified in the plan to the covered compensation of each employee under the plan. Thus, for example, if a plan specifies a single integration or offset level of $30,000 that is uniformly applicable to all employees for a plan year, the 0.75-percent factor in the maximum excess or offset allowance must be reduced to 0.60 percent for an employee with covered compensation of $20,000, but need not be reduced for an employee whose covered compensation is $30,000 or greater. (iv) Reductions(A) Table. (B) Interpolation. If the integration or offset level used under a plan is between the percentages of covered compensation in the table, the permitted disparity factor applicable to the plan can be determined either by straight-line interpolation between the permitted disparity factors in the table or by rounding the integration or offset level up to the next highest percentage of covered compensation in the table. (10) Examples. The following examples illustrate this paragraph (d). Unless otherwise provided, the following facts apply. The plan is noncontributory and is the only plan ever maintained by the employer. The plan uses a normal retirement age of 65 and contains no provision that would require a reduction in the 0.75-percent factor under paragraph (b)(2) or (b)(3) of this section. In the case of an offset plan, the plan provides that an employee's final average compensation is limited to the employee's average annual compensation. Each example discusses the benefit formula applicable to an employee who has a social security retirement age of 65.

Source

26 CFR § 1.401(l)-3


Scoping language

None
Is this correct? or