Cal. Code Regs. Tit. 13, § 1272 - Data Display and Chassis Certification
Current through Register 2022 Notice Reg. No. 16, April 25, 2022
School buses shall comply with the following:
(a) Display of Data. Plates or labels
displaying the following data shall be permanently attached in each school bus
except Type 2 school buses manufactured before July 1, 1970, and shall be
readily visible either in the driver's compartment or where prescribed in Part
567, Certification, of Title 49, Code of Federal Regulations:
(1) Gross vehicle weight rating
(GVWR)
(2) Minimum tire size and
minimum acceptable load range rating
(3) Gross axle weight rating (GAWR) -Front,
intermediate (if applicable), and rear
(4) Unladen weight of vehicle as defined in
Vehicle Code Section
660.
(5) For vehicles manufactured on or after
September 1, 1989 and classed as multipurpose passenger vehicles (MPV) as
defined in Part 571 of Title 49, Code of Federal Regulations, the statement:
"This multipurpose passenger vehicle meets or exceeds the requirements of all
Federal Motor Vehicle Safety Standards in effect on the date of manufacture for
a school bus having a Gross Vehicle Weight Rating of (10,000 pounds or less)
(More than 10,000 pounds)." The statement shall be completed with only one of
the GVWR ranges shown in parentheses, not by including both and striking out
one.
(b) Chassis
Manufacturer's Certification. A chassis shall not be used on either any Type 2
school bus manufactured on or after July 1, 1970, and prior to April 1, 1977,
or any Type 1 school bus manufactured prior to April 1, 1977, unless the
manufacturer of the chassis, as defined in Section1201 of this title, has filed
with the Commissioner a certified statement on the departmental form setting
forth the gross vehicle weight rating of such chassis. For buses manufactured
after January 1, 1973, and prior to April 1, 1977, the manufacturer of the
chassis shall file, on a departmental form, only a certified statement that the
models listed comply with all applicable laws and regulations.
(c) Chassis Modifications. Repowering with
other than original engines, or other chassis modifications shall be done only
with the written permission of the vehicle manufacturer(s) listed on the
Federal certification label or data plate. If such permission cannot be
obtained, a modification may be made if:
(1)
It duplicates an original installation or a previously approved installation on
the same make and model of school bus, or
(2) It is done in accordance with engineering
plans provided by the component manufacturer or an independent engineering
firm, and
(3) In either case, the
bus is reinspected by an authorized department employee before it is used for
pupil transportation.
Notes
Note: Authority and reference cited: Section 34508, Vehicle Code.
2. Amendment of subsection (c) filed 5-17-84; effective thirtieth day thereafter (Register 84, No. 20).
3. Amendment of subsection (a) filed 7-17-89; operation 8-16-89 (Register 89, No. 29).
4. Editorial correction adding text inadvertently omitted in printing (Register 91, No. 18).
The following state regulations pages link to this page.
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.