Article 98 - Operating Rules

  1. § 4990 - Scope
  2. § 4991 - Travel
  3. § 4991.1 - Ground Conditions
  4. § 4992 - Booms
  5. § 4993 - Swing
  6. § 4993.1 - Work Area Control
  7. § 4994 - Hoisting
  8. § 4995 - Riding Loads on Derricks, Hoists, or Cranes
  9. § 4996 - Driver's Position
  10. § 4997 - Fire Extinguisher
  11. § 4998 - Refueling
  12. § 4999 - Handling Loads
  13. § 5000 - Limit Switches
  14. § 5001 - Signals - General Requirements
  15. Plate I - Recommended Hand Signals for Controlling Crane Operations, version 2
  16. § 5001.1 - Signals - Radio, Telephone or Other Electronic Transmission of Signals
  17. § 5001.2 - Signals - Voice Signals - Additional Requirements
  18. § 5001.3 - Signal Person Qualifications - Supplemental Requirements for Cranes and Derricks in Construction
  19. § 5002 - Overhead Loads
  20. § 5003 - Provisions for Preventing Accidents in the Area of High-Voltage Lines
  21. § 5003.1 - Power Line Safety (up to and Including 350kv) - Equipment Operations
  22. § 5003.2 - Power Line Safety (over 350kv)
  23. § 5003.3 - Power Line Safety (All Voltages) - Equipment Operations Closer than the Table a Zone
  24. § 5003.4 - Power Line Safety - While Traveling Under or near Power Lines with NO Load
  25. § 5004 - Crane or Derrick Suspended Personnel Platforms
  26. § 5005 - Work near Transmitter Towers
  27. § 5006 - Crane and Hoisting Equipment Operators-Qualifications
  28. § 5006.1 - Mobile Crane and Tower Crane - Operator Qualifications and Certification (Applicable to Cranes in General Industry Only)
  29. § 5006.2 - Operator Training, Certification, and Evaluation for Cranes and Derricks in Construction
  30. § 5008 - Operating Practices
  31. § 5008.1 - Operation
  32. § 5009 - Floor-Operated Cranes
  33. § 5010 - Assembly/Disassembly - Selection of Manufacturer or Employer Procedures
  34. § 5010.1 - Assembly/Disassembly - General Requirements (Applies to All Assembly and Disassembly Operations)
  35. § 5010.2 - Disassembly - Additional Requirements for Dismantling of Booms and Jibs (Applies to Both the Use of Manufacturer Procedures and Employer Procedures)
  36. § 5010.3 - Assembly/Disassembly - Employer Procedures - General Requirements
  37. § 5010.4 - Power Line Safety (up to and Including 350kv) - Assembly and Disassembly
  38. § 5011 - Fall Protection - Supplemental/Specific Requirements for Cranes
  39. § 5012 - Training - Supplemental Requirements for Cranes in Construction

State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.

No prior version found.