1 CCR 301-25-37.0 - Rub Rails

37.1 There shall be one rub rail located on each side of the bus at approximately seat level which shall extend from the rear side of the service door completely around the bus body (except for emergency and/or access door) to the point of curvature near outside cowl on the left side.

37.2 There shall be one rub rail located at approximately the floor line which shall cover the same longitudinal areas as the upper rub rail, except at the wheel housing, and shall extend at least to the radii of the right and left rear corners

37.3 There shall be one rub rail located on each side of the bus at the bottom of the side skirts, or a side skirt stiffener of equivalent strength

37.4 Rub rails shall be attached at each body post and all other upright structural members.

37.5 Rub rails shall be four inches or more in width, 16-gauge steel, or equivalent strength, constructed in corrugated or ribbed fashion, and shall be self-draining.

37.6 Rub rails shall be applied to the outside of the body panels. Pressed-in or snap-on rub rails do not satisfy this requirement.

Notes

1 CCR 301-25-37.0

38 CR 07, April 10, 2015, effective 4/30/2015 46 CR 14, July 25, 2023, effective 8/14/2023 47 CR 19, October 10, 2024, effective 10/30/2024