Minn. R. 1341.0610 - A117.1 SECTION 610, SEATS
A117.1
Section 610.3 is amended to read as follows:
610.3
Shower Compartment Seats.
The height of the seat shall be 17 inches (430 mm) minimum and 19 inches (485
mm) maximum above the bathroom floor, measured to the top of the seat. In
transfer-type and alternate roll-in-type showers, the seat shall extend along
the seat wall to a point within 3 inches (76 mm) of the compartment entry. In
standard roll-in-type showers, the seat shall extend from the control wall to a
point within 3 inches (76 mm) of the compartment entry. Seats shall comply with
Section 610.3.1 or 610.3.2.
610.3.1
Rectangular Seats. The rear edge of a rectangular seat shall be 2-1/2
inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum to 16
inches (405 mm) maximum from the seat wall. The side edge of the seat shall be
1-1/2 inches (38 mm) maximum from the back wall of a transfer-type shower and
1-1/2 inches (38 mm) maximum from the control wall of a roll-in-type
shower.
610.3.2
L-Shaped
Seats. The rear edge of an L-shaped seat shall be 2-1/2 inches (64 mm)
maximum and the front edge 15 inches (380 mm) minimum to 16 inches (405 mm)
maximum from the seat wall. The rear edge of the "L" portion of the seat shall
be 1-1/2 inches (38 mm) maximum from the wall and the front edge shall be 14
inches (355 mm) minimum and 15 inches (380 mm) maximum from the wall. The end
of the "L" shall be 22 inches (560 mm) minimum and 23 inches (585 mm) maximum
from the main seat wall.
Notes
Statutory Authority: MS s 16B.37; 16B.59 to 16B.76; 326B.101 to 326B.194
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.