Minn. R. agency 151, ch. 1360, pt. 1360.2400 - MANUFACTURER'S COMPLIANCE CERTIFICATE
The compliance certificate form furnished by the state building inspector must contain but is not limited to the following information, and must be placed by the manufacturer in the vicinity of the electrical distribution panel or in some other approved designated location that is readily accessible for inspection:
A. manufacturer's name and address;
B. serial number of the unit;
C. model designation and name of manufacturer
of major factory-installed appliances;
D. where applicable, identification of
permissible type of gas for appliances and directions for water and drain
connections;
E. name and date of
standards complied with;
F. seal
serial number;
G. design
loads;
H. special conditions or
limitations of the unit;
I. date of
manufacture; and
J. electrical
ratings-instructions and warnings on voltage, phase, size and connections of
units, and grounding requirements.
Notes
Statutory Authority: MS s 16B.59 to 16B.73; 326B.101 to 326B.151
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.