Wash. Admin. Code § 296-807-18050 - Use proper flanges

(1) You must mount all abrasive wheels between flanges that have a diameter at least one-third the diameter of the wheel.

Exemption:

This requirement does not apply to the following types of wheels:

1. Mounted wheels;

2. Cup, cone or plug wheels with threaded inserts or projecting studs;

3. Abrasive disc wheels (inserted nut, inserted washer and projecting stud type);

4. Plate mounted wheels;

5. Cylinder, cup, or segmental wheels mounted in chucks;

6. Types 27, 28, and 29 wheels;

7. Internal wheels less than two inches in diameter;

8. Modified Type 6 and 11 wheels (terrazzo);

9. Types 1 and 27A cutting-off wheels.

(2) You must make sure flanges are:

(a) Dimensionally accurate;

(b) Properly balanced;

(c) Flat;

(d) Free of rough surfaces or sharp edges.

(3) You must make sure, if a wheel is mounted between two flanges, that both flanges:

(a) Are the same diameter;

(b) Have equal bearing surfaces.

Exemption:

The following wheels do not require same diameter, equal bearing surface flanges:

1. Types 27, 28, and 29 wheels with adaptors;

2. Modified Types 6 and 11 wheels with tapered K dimension;

3. Internal wheels less than two inches in diameter.

(4) You must make sure the driving flange is:

(a) Part of the spindle; or

(b) Securely fastened to the spindle.

Notes

Wash. Admin. Code § 296-807-18050

Amended by WSR 15-23-086, Filed 11/17/2015, effective 12/18/2015

Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060. 07-03-163, § 296-807-18050, filed 1/24/07, effective 4/1/07; 03-09-009, § 296-807-18050, filed 4/4/03, effective 8/1/03.