14 CFR 21.316 - Responsibility of holder.

Beta! The text on the eCFR tab represents the unofficial eCFR text at ecfr.gov.
§ 21.316 Responsibility of holder.

Each holder of a PMA must -

(a) Amend the document required by § 21.305 as necessary to reflect changes in the organization and provide these amendments to the FAA;

(b) Maintain the quality system in compliance with the data and procedures approved for the PMA;

(c) Ensure that each PMA article conforms to its approved design and is in a condition for safe operation;

(d) Mark the PMA article for which an approval has been issued. Marking must be in accordance with part 45 of this chapter, including any critical parts;

(e) Identify any portion of the PMA article (e.g., sub-assemblies, component parts, or replacement articles) that leave the manufacturer's facility as FAA approved with the manufacturer's part number and name, trademark, symbol, or other FAA approved manufacturer's identification;

(f) Have access to design data necessary to determine conformity and airworthiness for each article produced under the PMA;

(g) Retain each document granting PMA and make it available to the FAA upon request; and

(h) Make available to the FAA information regarding all delegation of authority to suppliers.

Title 14 published on 2015-01-01

The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 14 CFR Part 21 after this date.

  • 2015-10-15; vol. 80 # 199 - Thursday, October 15, 2015
    1. 80 FR 61975 - Final Primary Category Airworthiness Design Standards; AutoGyro USA, LLC (AutoGyro) Model Calidus Gyroplane
      GPO FDSys XML | Text
      DEPARTMENT OF TRANSPORTATION, Federal Aviation Administration
      Issuance of final Airworthiness Design Standards.
      These airworthiness design standards are effective November 16, 2015.
      14 CFR Part 21