Jump to navigation
Each item of installed equipment must -
(a) Be of a kind and design appropriate to its intended function;
(b) Be labeled as to its identification, function, or operating limitations, or any applicable combination of these factors;
(c) Be installed according to limitations specified for that equipment; and
(d) Function properly when installed.
This is a list of United States Code sections, Statutes at Large, Public Laws, and Presidential Documents, which provide rulemaking authority for this CFR Part.
This list is taken from the Parallel Table of Authorities and Rules provided by GPO [Government Printing Office].
It is not guaranteed to be accurate or up-to-date, though we do refresh the database weekly. More limitations on accuracy are described at the GPO site.
§ 106 - Federal Aviation Administration
§ 40113 - Administrative
§ 44701 - General requirements
§ 44702 - Issuance of certificates
§ 44704 - Type certificates, production certificates, airworthiness certificates,,11 So in original. and design and production organization certificates
Title 14 published on 2015-01-01
The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 14 CFR Part 27 after this date.
These special conditions are issued for the modification of the Airbus Helicopters Model EC120B helicopter. This model helicopter will have a novel or unusual design feature after installation of the S-TEC Corporation (S-TEC) HeliSAS helicopter autopilot/stabilization augmentation system (AP/SAS) that has potential failure conditions with more severe adverse consequences than those envisioned by the existing applicable airworthiness regulations. These special conditions contain the added safety standards the Administrator considers necessary to ensure the failures and their effects are sufficiently analyzed and contained.
The FAA is proposing to revise its rules for pilot compartment view to allow ground tests to demonstrate compliance for night operations. The current regulations require night flight testing to demonstrate compliance, which is not necessary in every case. The proposed rule would relieve the burden of performing a night flight test under certain conditions.
The FAA is announcing a public meeting to gather additional technical input on the subject of installing an engine inlet barrier filter (IBF) on rotorcraft. Input gathered will aid in developing FAA guidance for evaluating engine IBFs installed on rotorcraft. Prior to the public meeting, the FAA previously sought public comments regarding the guidance online.
This action reopens the comment period for the regulatory evaluation associated with the FAA's June 11, 2013 Notice of Proposed Rulemaking (NPRM), Revisions to Operational Requirements for the Use of Enhanced Flight Vision Systems (EFVS) and to Pilot Compartment View Requirements for Vision Systems. The regulatory evaluation associated with the NPRM was not posted to the docket prior to the close of the comment period. Therefore, the FAA is reopening the comment period to allow the public the opportunity to adequately analyze the full regulatory evaluation for the NPRM. The FAA will accept comments on the regulatory evaluation only; and not on the regulatory changes proposed in the NPRM.