14 CFR 29.1435 - Hydraulic systems.

§ 29.1435 Hydraulic systems.

(a)Design. Each hydraulic system must be designed as follows:

(1) Each element of the hydraulic system must be designed to withstand, without detrimental, permanent deformation, any structural loads that may be imposed simultaneously with the maximum operating hydraulic loads.

(2) Each element of the hydraulic system must be designed to withstand pressures sufficiently greater than those prescribed in paragraph (b) of this section to show that the system will not rupture under service conditions.

(3) There must be means to indicate the pressure in each main hydraulic power system.

(4) There must be means to ensure that no pressure in any part of the system will exceed a safe limit above the maximum operating pressure of the system, and to prevent excessive pressures resulting from any fluid volumetric change in lines likely to remain closed long enough for such a change to take place. The possibility of detrimental transient (surge) pressures during operation must be considered.

(5) Each hydraulic line, fitting, and component must be installed and supported to prevent excessive vibration and to withstand inertia loads. Each element of the installation must be protected from abrasion, corrosion, and mechanical damage.

(6) Means for providing flexibility must be used to connect points, in a hydraulic fluid line, between which relative motion or differential vibration exists.

(b)Tests. Each element of the system must be tested to a proof pressure of 1.5 times the maximum pressure to which that element will be subjected in normal operation, without failure, malfunction, or detrimental deformation of any part of the system.

(c)Fire protection. Each hydraulic system using flammable hydraulic fluid must meet the applicable requirements of §§ 29.861, 29.1183, 29.1185, and 29.1189.

This is a list of United States Code sections, Statutes at Large, Public Laws, and Presidential Documents, which provide rulemaking authority for this CFR Part.

This list is taken from the Parallel Table of Authorities and Rules provided by GPO [Government Printing Office].

It is not guaranteed to be accurate or up-to-date, though we do refresh the database weekly. More limitations on accuracy are described at the GPO site.

United States Code

Title 14 published on 03-May-2017 03:58

The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 14 CFR Part 29 after this date.

  • 2017-02-08; vol. 82 # 25 - Wednesday, February 8, 2017
    1. 82 FR 9677 - Revisions to Operational Requirements for the Use of Enhanced Flight Vision Systems (EFVS) and to Pilot Compartment View Requirements for Vision Systems
      GPO FDSys XML | Text
      DEPARTMENT OF TRANSPORTATION, Federal Aviation Administration
      Final rule; delay of effective date.
      The effective date of the rule amending 14 CFR parts 1, 23, 25, 27, 29, 61, 91, 121, 125, and 135 published at 81 FR 90126, December 13, 2016, is delayed until March 21, 2017, except for the amendments to §§ 61.66 (amendatory instruction no. 15), 91.175 (amendatory instruction no. 18), 91.1039 (amendatory instruction no. 23), 121.651 (amendatory instruction no. 27), 125.325 (amendatory instruction no. 33), 125.381 (amendatory instruction no. 35), and 135.225 (amendatory instruction no. 38), which are effective March 13, 2018.
      14 CFR Parts 1, 23, 25, 27, 29, 61, 91, 121, 125, and 135