16 CFR 460.13 - Fact sheets.

§ 460.13 Fact sheets.

If you are a manufacturer, you must give retailers and installers fact sheets for the insulation products you sell to them. Each sheet must contain what is listed here. You can add any disclosures that are required by federal laws, regulations, rules, or orders. You can add any disclosures that are required by State or local laws, rules, and orders, unless they are inconsistent with the provisions of this regulation. Do not add anything else.

Each fact sheet must contain these items:

(a) The name and address of the manufacturer. It can also include a logo or other symbol that the manufacturer uses.

(b) A heading: “This is ____ insulation.” Fill in the blank with the type and form of your insulation.

(c) The heading must be followed by a chart:

(1) If § 460.12(b) requires a chart for your product's label, you must use that chart. For foamed-in-place insulations, you must show the R-value of your product at 3 1/2 inches. You can also show R-values at other thicknesses.

(2) You can put the charts for similar products on the same fact sheet. For example, if you sell insulation boards or batts in three different thicknesses, you can put the label charts for all three products on one fact sheet. If you sell loose-fill insulation in two different bag sizes, you can put both coverage charts on one fact sheet, as long as you state which coverage chart applies to each bag size.

(d) For air duct insulation, the chart must be followed by this statement:

“The R-value of this insulation varies depending on how much it is compressed during installation.”

(e) After the chart and any statement dealing with the specific type of insulation, ALL fact sheets must carry this statement, boxed, in 12-point type:

Read This Before You Buy

What You Should Know About R-values

The chart shows the R-value of this insulation. R means resistance to heat flow. The higher the R-value, the greater the insulating power. Compare insulation R-values before you buy.

There are other factors to consider. The amount of insulation you need depends mainly on the climate you live in. Also, your fuel savings from insulation will depend upon the climate, the type and size of your house, the amount of insulation already in your house, and your fuel use patterns and family size. If you buy too much insulation, it will cost you more than what you'll save on fuel.

To get the marked R-value, it is essential that this insulation be installed properly.

[ 44 FR 50242, Aug. 27, 1979, as amended at 45 FR 68928, Oct. 17, 1980; 70 FR 31276, May 31, 2005]

This is a list of United States Code sections, Statutes at Large, Public Laws, and Presidential Documents, which provide rulemaking authority for this CFR Part.

This list is taken from the Parallel Table of Authorities and Rules provided by GPO [Government Printing Office].

It is not guaranteed to be accurate or up-to-date, though we do refresh the database weekly. More limitations on accuracy are described at the GPO site.

United States Code
Statutes at Large

Title 16 published on 14-Jun-2017 03:58

The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 16 CFR Part 460 after this date.

  • 2016-06-03; vol. 81 # 107 - Friday, June 3, 2016
    1. 81 FR 35661 - Labeling and Advertising of Home Insulation
      GPO FDSys XML | Text
      Advance notice of proposed rulemaking; extension of deadline for submission of public comments.
      The comment period for the advance notice of proposed rulemaking published April 6, 2016 (81 FR 19936), is extended. Comments must be received on or before September 6, 2016.
      16 CFR Part 460
The section you are viewing is cited by the following CFR sections.