40 CFR Appendix Table 21 to Subpart UUU of Part 63, Continuous Compliance With Operating Limits for Organic HAP Emissions From Catalytic Reforming Units
Table 21 to Subpart UUU of Part 63 - Continuous Compliance With Operating Limits for Organic HAP Emissions From Catalytic Reforming Units
As stated in § 63.1566(c)(1), you shall meet each requirement in the following table that applies to you.
|For each applicable process vent for a new or existing catalytic reforming unit . . .||If you use . . .||For this operating limit . . .||You shall demonstrate continuous compliance during initial catalyst depressuring and purging operations by . . .|
|1. Option 1||Flare||The flare pilot light must be present at all times and the flare must be operating at all times that emissions may be vented to it||On and after January 30, 2019, meeting the requirements of
|2. Option 2||a. Thermal incinerator boiler or process heater with a design input capacity under 44 MW or boiler or process heater in which not all vent streams are not introduced into the flame zone||Maintain the daily average combustion zone temperature above the limit established during the performance test||Collecting, the hourly and daily temperature monitoring data according to
|b. No control device||Operate at all times according to your operation, maintenance, and monitoring plan regarding minimum purging conditions that must be met prior to allowing uncontrolled purge releases||Recording information to document compliance with the procedures in your operation, maintenance, and monitoring plan.|