Jump to navigation
This is a list of United States Code sections, Statutes at Large, Public Laws, and Presidential Documents, which provide rulemaking authority for this CFR Part.
This list is taken from the Parallel Table of Authorities and Rules provided by GPO [Government Printing Office].
It is not guaranteed to be accurate or up-to-date, though we do refresh the database weekly. More limitations on accuracy are described at the GPO site.
§ 300f - Definitions
§ 300h - Regulations for State programs
Title 40 published on 2015-08-22
The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 40 CFR Part 141 after this date.
The Environmental Protection Agency (EPA) is extending the comment period for the proposed rule, “Use of Lead Free Pipes, Fittings, Fixtures, Solder and Flux for Drinking Water.” In response to a stakeholder request, EPA is extending the comment period for an additional 30 days, from April 17, 2017, to May 17, 2017.
The Environmental Protection Agency (EPA) proposes to make conforming changes to existing drinking water regulations based on the Reduction of Lead in Drinking Water Act of 2011 (RLDWA) and the Community Fire Safety Act of 2013 (CFSA). Section 1417 of the Safe Drinking Water Act (SDWA) prohibits the use and introduction into commerce of certain plumbing products that are not lead free. The RLDWA revised the definition of lead free to lower the allowable maximum lead content from 8.0 percent to a weighted average of 0.25 percent of the wetted surfaces of plumbing products and established a statutory method for calculating lead content. In addition, the RLDWA created exemptions from the lead free requirements for plumbing products that are used exclusively for nonpotable services as well as for other specified products. The CFSA further amended section 1417 to exempt fire hydrants from these requirements. EPA proposes to establish new requirements to assure that individuals purchasing, installing or inspecting potable water systems can identify lead free plumbing materials. Specifically, EPA proposes to establish labeling requirements to differentiate plumbing products that meet the lead free requirements from those that are exempt from the lead free requirements and to require manufacturers to certify compliance with the lead free requirements. These proposed requirements would reduce inadvertent use of non-lead free plumbing products in potable use applications and, consequently, reduce exposure to lead in drinking water and associated adverse health effects.
The Safe Drinking Water Act (SDWA) requires the U.S. Environmental Protection Agency (EPA) to conduct a review every six years of existing national primary drinking water regulations (NPDWRs) and determine which, if any, need to be revised. The purpose of the review, called the Six-Year Review, is to evaluate current information for regulated contaminants to determine if there is new information on health effects, treatment technologies, analytical methods, occurrence and exposure, implementation and/or other factors that provides a health or technical basis to support a regulatory revision that will improve or strengthen public health protection. EPA has completed a detailed review of 76 NPDWRs and at this time has determined that eight NPDWRs are candidates for regulatory revision. The eight NPDWRs are included in the Stage 1 and the Stage 2 Disinfectants and Disinfection Byproducts Rules, the Surface Water Treatment Rule, the Interim Enhanced Surface Water Treatment Rule and the Long Term 1 Enhanced Surface Water Treatment Rule. EPA requests comments on the eight NPDWRs identified as candidates for revision and will consider comments and data as it proceeds with determining whether further action is needed. In addition, as part of this Six-Year Review, EPA identified 12 other NPDWRs that were or continue to be addressed in recently completed, ongoing or pending regulatory actions. EPA thus excluded those 12 NPDWRs from detailed review. This document is not a final regulatory decision, but rather the initiation of a process that will involve more detailed analyses of factors relevant to deciding whether a rulemaking to revise an NPDWR should be initiated.
The U.S. Environmental Protection Agency (EPA) is finalizing a Safe Drinking Water Act (SDWA) rule that requires public water systems to collect occurrence data for contaminants that may be present in drinking water but are not yet subject to EPA's drinking water standards set under the SDWA. This rule identifies eleven analytical methods to support water system monitoring for a total of 30 chemical contaminants, consisting of nine cyanotoxins and one cyanotoxin group; two metals; eight pesticides plus one pesticide manufacturing byproduct (hereinafter collectively referred to as “pesticides”); three brominated haloacetic acid disinfection byproduct groups; three alcohols; and three semivolatile organic chemicals. EPA is also announcing a public meeting and webinar to discuss the implementation of the fourth Unregulated Contaminant Monitoring Rule.
This action announces the U.S. Environmental Protection Agency's (EPA's) approval of alternative testing methods for use in measuring the levels of contaminants in drinking water and determining compliance with national primary drinking water regulations. The Safe Drinking Water Act authorizes EPA to approve the use of alternative testing methods through publication in the Federal Register . EPA is using this streamlined authority to make 16 additional methods available for analyzing drinking water samples. This expedited approach provides public water systems, laboratories, and primacy agencies with more timely access to new measurement techniques and greater flexibility in the selection of analytical methods, thereby reducing monitoring costs while maintaining public health protection.
The U.S. Environmental Protection Agency (EPA) is announcing final regulatory determinations not to issue national primary drinking water regulations for four of the 116 contaminants listed on the Third Contaminant Candidate List. The Safe Drinking Water Act, as amended in 1996, requires the EPA to make regulatory determinations every five years on at least five unregulated contaminants. A regulatory determination is a decision about whether or not to begin the process to propose and promulgate a national primary drinking water regulation for an unregulated contaminant. On October 20, 2014, the agency published its preliminary determinations not to regulate dimethoate, 1,3-dinitrobenzene, terbufos, terbufos sulfone and begin the process to regulate strontium. The agency requested public comment on the determinations, process, rationale and supporting technical information. The agency received comments from 14 individuals or organizations on the preliminary regulatory determinations. After careful review and consideration of the public comments, the agency is making a final determination not to regulate dimethoate, 1,3-dinitrobenzene, terbufos and terbufos sulfone. The agency, however, is delaying the final regulatory determination on strontium in order to consider additional data and decide whether there is a meaningful opportunity for health risk reduction by regulating strontium in drinking water.
The U.S. Environmental Protection Agency (EPA) is proposing a Safe Drinking Water Act (SDWA) rule that requires public water systems to collect occurrence data for contaminants that may be present in tap water but are not yet subject to EPA's drinking water standards set under SDWA. This rule, revised every five years as required by SDWA, benefits public health by providing EPA and other interested parties with scientifically valid data on the national occurrence of selected contaminants in drinking water, such as cyanotoxins associated with harmful algal blooms. This data set is one of the primary sources of information on occurrence, levels of exposure and population exposure the Agency uses to develop regulatory decisions for emerging contaminants in the public drinking water supply. This proposal identifies eleven analytical methods to support water system monitoring for a total of 30 chemical contaminants/groups, consisting of ten cyanotoxins/groups; two metals; eight pesticides plus one pesticide manufacturing byproduct (hereinafter collectively referred to as “pesticides”); three brominated haloacetic acid groups of disinfection byproducts; three alcohols; and three semivolatile organic chemicals. EPA is also announcing a public webinar to discuss this proposal of the fourth Unregulated Contaminant Monitoring Rule.