18 AAC 30.545 - Operation
(a) No pool may operate without plan review
and approval and a pre-occupancy inspection as specified in
18 AAC 30.950 to confirm
compliance with
18 AAC 30.500 -
18 AAC 30.590.
(b) Pools and fixtures must be kept in a
sanitary condition when the pool is open to bathers. Premises must be kept in
good repair, well drained, and free from roaches, flies, rodents, and other
pests or conditions likely to attract or harbor these pests. If pests are
discovered in the pool or in the premises of the pool, the department will, in
its discretion, require a facility operator to secure pest control services
from an operator certified under 18 AAC 90.
(c) Pool surfaces, including side walls,
bottoms, gutters, and components, must be kept clean and in good repair.
(d) Appropriate test equipment in good
repair, with necessary reagents, must be used to measure pool water pH, free
and combined disinfectants, alkalinity, total dissolved solids, and hardness.
Test kits must meet the minimum range and accuracy as set out on Table D of
this section.
TABLE D TEST KIT REQUIREMENTS CHEMICAL TEST MINIMUM RANGE MINIMUM ACCURACY
Free available chlorine 0.3 - 5.0 mg/l0.2 mg/lTotal chlorine 0.3 - 5.0 mg/l0.2 mg/lTotal bromine 0.3 - 6.0 mg/l0.2 mg/lpH7.0 - 8.20.2 ph unitsAlkalinity 0 - 300 mg/l5 mg/lTotal dissolved solids 0 - 3,000 mg/l50 mg/lHardness 0 - 1,000 mg/l2 mg/l Note: 1 mg/l = 1 ppm
(e) Pools must be operated by
persons familiar with the equipment, fixtures, pool water chemistry, and
maintenance procedures. Pools and spas must have at least one operator who is
certified, or will be certified within one year of that operator's date of
employment, by the National Swimming Pool Foundation or an equivalent
certification program as determined by the department.
(f) To ensure proper installation, operation,
and maintenance, a pool operation manual must be available at the site of the
pool. The manual must include
(1) instructions
for the care of each filter, pump, and other pool equipment;
(2) drawings, illustrations, charts, and
operating instructions;
(3) a parts
list; and
(4) information on all
chemicals used in pool operation.
(g) The following information must be
recorded for each day that the pool is open to the public:
(1) the hours of operation;
(2) the length of time that the pumps and
filters are in operation, and the rate of pressure, vacuum, and rate-of-flow
readings;
(3) the date that each
filter is backwashed or cleaned;
(4) the frequency and results of alkalinity
and hardness tests;
(5) the
frequency and results of pH and disinfectant tests; pH and disinfectant tests
must be made two or more times daily, depending upon chlorine demand;
(6) the amount of water and chemicals added
to maintain water quality; and
(7)
any equipment failure or repair required while the pool is in
operation.
(h) The
department will, in its discretion, require copies of the records listed in (g)
of this section to be submitted to the department, upon the request of the
department.
(i) Water clarity must
permit a one-inch black disk on a three-inch white field to be clearly visible
on the bottom of the pool at the deepest point. If the test disk cannot be
seen, the pool must be closed immediately until the disk can be seen. If the
disk is still not visible 48 hours after closure, the department will, in its
discretion, order the pool drained as a safety precaution.
Notes
Authority:AS 44.46.020
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.