Ariz. Admin. Code § R18-2-722 - Standards of Performance for Existing Gravel or Crushed Stone Processing Plants

A. The provisions of this Section are applicable to the following affected facilities: primary rock crushers, secondary rock crushers, tertiary rock crushers, screens, conveyors and conveyor transfer points, stackers, reclaimers, and all gravel or crushed stone processing plants and rock storage piles.

B. No person shall cause, allow or permit the discharge of particulate matter into the atmosphere except as fugitive emissions in any one hour from any gravel or crushed stone processing plant in total quantities in excess of the amounts calculated by one of the following equations:

1. For process sources having a process weight rate of 60,000 pounds per hour (30 tons per hour) or less, the maximum allowable emissions shall be determined by the following equation:

E = 4.10P^0.67

where:

E = the maximum allowable particulate emissions rate in pounds-mass per hour.

P = the process weight rate in tons-mass per hour.

2. For process sources having a process weight rate greater than 60,000 pounds per hour (30 tons per hour), the maximum allowable emissions shall be determined by the following equation:

E = 55.0P^0.11 -40

where "E" and "P" are defined as indicated in subsection (B)(1).

C. Actual values shall be calculated from the applicable equations and rounded off to two decimal places.

D. Spray bar pollution controls shall be utilized in accordance with "EPA Control of Air Emissions From Process Operations In The Rock Crushing Industry" (EPA 340/1-79-002), "Wet Suppression System" (pages 15-34, amended as of January 1979 (and no future amendments or editions)), as incorporated herein by reference and on file with the Office of the Secretary of State, with placement of spray bars and nozzles as required by the Director to minimize air pollution.

E. Fugitive emissions from gravel or crushed stone processing plants shall be controlled in accordance with R18-2-604 through R18-2-607.

F. The owner or operator of any affected facility subject to the provisions of this Section shall install, calibrate, maintain, and operate monitoring devices which can be used to determine daily the process weight of gravel or crushed stone produced. The weighing devices shall have an accuracy of ± 5% over their operating range.

G. The owner or operator of any affected facility shall maintain a record of daily production rates of gravel or crushed stone produced.

H. The test methods and procedures required by this Section are as follows:

1. The reference methods in 40 CFR 60, Appendix A, as incorporated by reference in Appendix 2 of this Chapter, shall be used to determine compliance with the standards prescribed in this Section as follows:

a. Method 5 for concentration of particulate matter and moisture content,

b. Method 1 for sample and velocity traverses,

c. Method 2 for velocity and volumetric flow rate,

d. Method 3 for gas analysis.

2. For Method 5, the sampling time for each run shall be at least 60 minutes and the minimum sample volume is 0.85 dscm (30 dscf), except that shorter sampling times or smaller volumes, when necessitated by process variables or other factors, may be approved by the Director. Sampling shall not be started until 30 minutes after start-up and shall be terminated before shutdown procedures commence. The owner or operator of the affected facility shall eliminate cyclonic flow during performance tests in a manner acceptable to the Director.

Notes

Ariz. Admin. Code § R18-2-722

Section R18-2-722 renumbered from R18-2-522 and amended effective November 15, 1993 (Supp. 93-4). Amended by final rulemaking at 15 A.A.R. 281, effective March 7, 2009 (Supp. 09-1).