Ariz. Admin. Code § R9-14-613 - Compliance Testing for Waste Parameters
A. A licensee for a laboratory at which
compliance testing for waste parameters is performed shall ensure that each
waste sample for Arizona compliance testing is analyzed using an approved
method:
1. Listed in Table 6.2.C ;
or
2. Approved by the Department
for waste compliance testing under
R9-14-610(E).
B. A licensee for a laboratory at
which compliance testing for waste parameters is performed using an 8000 series
method from Key Reference F shall:
1. If the
method includes specific quality control requirements, follow the specific
quality control requirements in the method;
2. If the method does not include specific
quality control requirements, follow all requirements in Key Reference F14;
and
3. If the method does not
include specific sample extraction procedures, follow the procedures in the
following from Key Reference F, as applicable:
a. Method 3500B,
b. Method 3600C, or
c. Method 5000.
C. A licensee for a laboratory at
which compliance testing for waste parameters is performed using a non-8000
series method from Key Reference F shall comply with the following from Key
Reference F, as applicable, according to the requirements of the specific
method:
1. Method 4000, or
2. Methods 7000B and 7010.
D. A licensee for a laboratory at
which compliance testing for waste parameters is performed using a method from
Key Reference F shall comply with Chapters 1 through 8 of Update IV, February
2007, of Key Reference F, as applicable, according to the requirements of the
specific method.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.