For those applicants proposing to implement the Permit
Basin Discharge Monitoring Program, the District-approved monitoring plan will
be incorporated into a modified General Permit and the following limiting
conditions shall be met in addition to the conditions indicated in Rule
40E-63.444, F.A.C. These
limiting conditions will be attached to the General Permit.
(1) The discharge (quantity and quality)
monitoring plan shall provide reasonable assurance that the annual water
discharge and total phosphorus load are accurately documented.
(2) The approved discharge monitoring plan
shall be incorporated by reference and made part of this permit;
(3) The equipment shall be installed and the
monitoring shall start no later than 30 days after the permit issuance date.
Within 60 days after the permit issuance date, the permittee shall contact the
District to verify that installation of the monitoring equipment is complete
and to schedule an inspection;
(4)
The permittee shall implement the discharge monitoring plan in accordance with
the permit and shall submit to the District any proposed modification of the
plan by submitting an application to modify the permit for review and approval
prior to implementation.
(5) The
location of sample collection shall be such that water sampled is
representative of all water from the monitored area that discharges
off-site.
(6) All water quality
sample collection, preservation, handling, transport, and chain-of-custody
documentation shall be conducted in accordance with an approved Comprehensive
Quality Assurance Plan as specified in the approved discharge monitoring plan.
All laboratory analyses shall be conducted by a laboratory with proper
certification for the specified parameter (e.g. phosphorus);
(7) In the event that water quality automatic
sampling equipment becomes inoperable for any reason, grab samples shall be
temporarily taken on a daily basis during flow events and composited for a
maximum of 14 days for total phosphorus analysis. Reasonable effort must be
made to render the automatic sampling equipment operable within 14
days;
(8) Monitoring conditions may
be reduced or adjusted upon submission of data and/or studies that provide the
basis for such, reasonably demonstrating that equivalent data will be obtained
with the reduction or adjustment in monitoring;
(9) The District will provide at least one
week notice to the permittee of the intent to conduct a quality assurance field
audit of the sampling collection procedures;
(10) The water quantity and quality data
shall be submitted to the District no later than 60 days from the last day of
the sampling period being reported. Water quantity and quality data shall be
submitted to the District in an approved electronic format on a monthly
basis.
(11) All flow quantity
discharged from the property shall be calculated using a method proposed by a
Florida-registered Professional Engineer in a Calibration Report approved by
the District. A Calibration Report shall be required for each pump, culvert or
other discharge structure. The report shall also quantify uncontrolled off-site
discharges, such as overland sheet flow. Each Calibration Report shall contain,
at a minimum: data collection methodology, instrumentation and procedures; the
actual field data collected; the basis for the full operating range represented
by the data; the methodology for development of the calibration equation;
operational information needed to calculate flow with a temporary backup
methodology to be used if the primary equipment becomes inoperable; and the
final calibration equation and primary method for calculating the flow. Any
modification to the approved calibration shall require an application to modify
the existing permit.
(12) During
periods of off-site discharge, water quality composite samples shall be
collected by automatic sampler, preserved, and the composite sample shall be:
a) removed from the sample collection site
and delivered to the laboratory no later than 21 days from the time the first
individual sample was taken and,
b)
analyzed for total phosphorus no later than 28 days from the time the first
individual sample was taken.