Ga. Comp. R. & Regs. R. 120-3-27-.10 - Maintenance and Inspection Records
(1) The owner shall retain at all times
up-to-date maintenance records for each amusement ride.
(2) These records shall contain the following
information:
(a) Date and nature of all
inspections;
(b) Any violation of
the rules and type of action taken to rectify the violation;
(c) All breakdowns or repairs of any major
mechanical part.
(3)
Maintenance of equipment shall be in accordance with this Chapter; and any
replacements thereof shall be in conformity with this Chapter. Only those bolts
of grade 5 or better will be used except where stronger grade bolts are
required by manufacturer.
(4)
Repairs: In accordance with manufacturers recommendations only those procedures
acceptable will be allowed.
(5) An
amusement ride shall be inspected and tested on each day when it is intended to
be used. The inspection and test shall be made by a qualified person
experienced and instructed in the proper assembly and operation of the device
and shall be performed before the ride is put into normal operation.
(6) The inspection and test shall include the
operation of control devices, speed-limiting devices, brakes and other
equipment provided for safety.
(7)
All amusement rides shall have an operating manual. The owner of an amusement
ride shall operate the ride in accordance with the manufacturer's operating
manual. In the absence of a manufacturer's operating manual, the owner shall
write an approved operating manual. Where any conflict occurs between the
operating manual and this Chapter, this Chapter shall prevail. The operating
manual shall be kept with the amusement ride and shall be available for use by
the office of Safety Engineering at all times.
(8) Welding of parts upon which safe
operation depends, will be in accordance to AWS Standards welding & brazing
procedures done by welders qualified to those procedures, procedures shall be
provide by the manufacturer.
(9)
The requirements for welding procedures and welder qualifications use, AWS
D1.1, D1.2, D1.3, D1.6 and C3.4 (American Welding Society Standards for the
welding of steel, aluminum, sheet metal and stainless steel and torch
brazing.)
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.