Mich. Admin. Code R. 408.31136 - Manufacturer's data plate
Rule 1136.
(1)
The following information shall be placed directly on 1 or more permanent
manufacturer's data plates in the vicinity of the electrical distribution panel
or in some other designated location acceptable to the commission, on the
premanufactured unit or building component where it will be readily accessible
for inspection:
(a) Manufacturer's name and
address.
(b) Serial number of the
unit.
(c) Label serial
number.
(d) Name and date of
applicable nationally recognized codes complied with.
(e) Model designation and name of
manufacturer of major factory installed appliances.
(f) Identification of permissible type of gas
for appliances and directions for water and drain connection.
(g) Snow, wind, seismic and other live
loads.
(h) Electrical ratings and
instructions and warnings on voltage.
(i) Special conditions or limitations on use
of the unit, including unsuitability for areas in which specified environmental
conditions prevail.
(j) Date of
manufacture.
(2) If, in
the opinion of the bureau, the shape or size of a building component is such
that the information required in subrule (1) cannot be attached to a component
permanently, the information may be placed in a manual crated with the
component or on a tag attached to the crate in which the component is shipped,
if the information is not such that the future occupant of the building should
know it. If the occupant will need to know the information, it shall be
contained in a manual which shall be presented to the occupant upon transfer of
possession. If life safety is involved, the item in question shall be plainly
labeled.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.