This subpart describes the standard information that is required in a capped permit application. This subpart does not limit the agency's statutory authority for requiring information in addition to that which is specifically listed. Applicants must submit the following information as required by the standard application form:
D. The following emissions-related information:
(1) A permit application shall provide the information required by this part for every emissions unit within the stationary source, except as provided otherwise in subitems (2) to (9) and information about fugitive emissions in the same manner as stack emissions, except that fugitive dust emissions from activities in part 7007.1300, subpart 3, item G, must be included in the calculations under this subpart only if the stationary source is in a category in part 7007.0200, subpart 2, item B, subitems (1) to (27).
(2) The application shall include information about insignificant activities and conditionally insignificant activities as follows:
(a) For capped permit option 1, the application need not include the information required by this part for any activity listed on the insignificant activities list in part 7007.1300, subpart 2, and those activities in subpart 3 for which emission factors or other calculation methods do not exist. The application shall include a list identifying all activities at the stationary source described in part 7007.1300, subpart 3, of the insignificant activities list and conditionally insignificant activities described in chapter 7008. The owner or operator shall also provide a calculation of emissions from any activity described in part 7007.1300, subpart 3, for which emission factors or calculation methods exist and conditionally insignificant activities except as otherwise allowed by this subpart.
(b) For capped permit option 2, the application need not include the information required by this part for any activity listed on the insignificant activities list in part 7007.1300 or for conditionally insignificant activities described in chapter 7008, except as provided in this subitem. The application shall include a list identifying any activity at the stationary source described in part 7007.1300, subpart 3, and conditionally insignificant activities. If requested by the agency, the owner or operator shall provide a calculation of emissions from any activity described in part 7007.1300, subpart 3, and conditionally insignificant activities. The agency shall request such a calculation if it finds that the emissions from those activities, in addition to other emissions from the stationary source, could make the stationary source subject to different applicable requirements under parts 7007.0100 to 7007.1850 or not eligible for capped permit option 2 under parts 7007.1140 to 7007.1148.
(3) A permit application shall identify and describe each emission point in sufficient detail to verify the applicability of all applicable requirements. This shall include the location of all emission points and the location of all emissions units and processes venting through each emission point, the exhaust gas flow rate and temperature, and the stack height and diameter of an emission point.
(4) The permit application shall specify the potential emissions, as defined in part 7005.0100, subpart 35a, in pounds per hour from each emission unit and actual emissions in tons per year from the stationary source as a whole. These emissions shall be specified for each regulated air pollutant and each hazardous air pollutant that is not yet a regulated air pollutant, as defined in part 7007.0100, subparts 12a and 19, except that pollutants which are regulated solely under section 112(r) of the act need not be included and pollutants regulated solely under section 602 of the act need not be included.
(5) A permit application shall include the following information to the extent it is emissions-related: fuels, fuel use, raw materials, production rates, and operating schedules.
(6) If the calculations required by part 7007.1147 used control equipment efficiencies for listed control equipment determined by part 7011.0070, the permit application shall identify and describe the listed control equipment.
(7) A permit application must explain the means by which the emissions information in subitems (1) to (9) is gathered, and provide the calculations on which they are based. Emission calculations may be done using an agency worksheet if one exists for an emission unit or process.
(8) The calculations required by part 7007.1147, and the total actual emissions per pollutant that result from those calculations. If the stationary source has not been operated or has operated less than 12 months, the owner or operator shall estimate the 12-month sum of actual emissions in performing the calculations required by part 7007.1147.
(9) Identification of the method the source used to comply with part 7007.1148, ambient air quality assessment and a summary of the assessment results.