Nev. Admin. Code § 534.340 - Well Driller's Report: Form; contents
1. A Well Driller's
Report must be submitted to the State Engineer within 30 days after the
completion of the drilling, plugging or rehabilitation of a well by the well
driller pursuant to
NRS
534.170 and must be typewritten or legibly
handwritten in black ink on a form provided by the Division. Submission of a
Well Driller's Report is not required for the reconditioning of an existing
well.
2. In addition to the
information required pursuant to
NRS
534.170, the following information must be
contained in the Well Driller's Report:
(a)
The complete name and address of the person for whom the work is being
performed.
(b) The location of the
well, including:
(1) A description of its
location by public land survey and county assessor's parcel number.
(2) Global positioning system coordinates
which:
(I) Are either identified by latitude
and longitude using decimal degrees or are identified using coordinates of the
Universal Transverse Mercator system; and
(II) Specify for each coordinate whether the
North American Datum of 1927, North American Datum of 1983 or the World
Geodetic System 1984 was used.
(3) In a Well Driller's Report for a well
drilled for domestic use, the address of the house to be served by the well,
the county assessor's parcel number and, if available, the lot and block
description and the name of the subdivision.
(c) Any pumping test or development
data.
(d) An accurate
identification of the water-bearing formations.
(e) The static water level, measured from the
land surface.
(f) Any applicable
water rights permit or waiver number.
(g) The temperature of the water in the well
measured in degrees Fahrenheit.
3. An accurate description of the
perforations in the casing must be set forth in the section of the Well
Driller's Report that contains a record of the well casing.
4. If the well is tested by:
(a) Pumping pursuant to subsection 3 of
NRS
534.170, the information must be reported on
the Well Driller's Report in gallons per minute of flow.
(b) Flow, the length of time it takes to fill
a container of known capacity, if the flow is not too large to be accurately
measured in that manner, must be reported on the Well Driller's Report.
The duration of such testing must not exceed 72 hours, unless otherwise approved by the Division.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.