N.M. Admin. Code § 14.12.5.8 - GENERAL INSTALLATION REQUIREMENTS (NEW OR USED; PRE-OWNED OR RESOLD)
The following requirements apply to new, used, pre-owned or resold manufactured homes, unless otherwise indicated.
A. Manufactured homes produced under the
Federal Manufactured Home Construction and Safety Standards Act must be
installed, including completion of all factory installed connections from the
unit to the necessary utilities, by persons licensed as a manufactured home
installer or repairman under the provisions of 14.12.2 NMAC.
B. No person shall install a new or pre-owned
manufactured home without first obtaining a permit for installation from the
manufactured housing division.
C. A
homeowner may secure a permit, when the homeowner assumes responsibility and
does the work on their home on a single site.
D. No utility supplier shall have a
connection from a supply of electricity, water, liquefied petroleum gas,
natural gas or sewer without first obtaining a permit for installation from the
division.
E. No utilities shall be
connected until the home is properly installed upon a permanent foundation, or
a non-permanent foundation.
F.
Utility connections for electricity, water, natural gas or sewer from on-site
utility terminals to a new, used, or pre-owned or resold manufactured home
produced under the Federal Manufactured Home Construction and Safety Standards
Act shall be made according to the manufacture's installation
instructions.
G. If the
manufacture's installation instructions are not available for installation of a
used, or pre-owned or resold manufactured home, the installation shall be made
according to the regulations herein.
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.