N.M. Admin. Code § 19.15.40.7 - DEFINITIONS
A.
"Accessible" means having access to; may require the removal of a
panel, door or similar covering of the item described.
B.
"Approved" means acceptable
to the authority having jurisdiction.
C.
"Authority having
jurisdiction" means the New Mexico LP gas bureau.
D.
"Bulk plant" means storage
facilities for liquid LP gas awaiting transfer.
E.
"Bureau" means the liquefied
petroleum and compressed gas bureau of the division.
F.
"Certified" means "listed" or
"labeled".
G.
"Certificate of
competence" means a written certificate issued by the LP gas bureau to
an LP gas installer based on evidence of competence.
H.
"Clearance" means the
distance between the appliance, chimney, vent chimney or vent connector, or
plenum and the nearest surface.
I.
"Code" means NFPA 52, NFPA 54, NFPA 57, NFPA 58 and NFPA 1192 and
other codebooks adopted as amended by the commission.
J.
"Commission" means the
construction industries commission.
K.
"Compressed natural gases"
and "CNG" means mixtures of hydrocarbon gases and vapors
consisting principally of methane in gaseous form, which has been compressed
for vehicular fuel.
L.
"Concealed LP gas piping" means all LP gas piping and fittings
which, when in place in the finished building, would require removal of
permanent construction to gain access to the piping.
M.
"Connector, gas appliance"
means a connector, used to convey fuel gas three feet or less in length (six
feet or less for gas ranges), between a gas shut off valve and gas appliance in
the same room.
N.
"Consumer's
LP gas system" means any arrangement of LP gas piping, extending from
the point of delivery to and including all outlets, appliances and
appurtenances, installed under the provisions of the code, which the consumer
is responsible to maintain in a serviceable condition, exclusive of piping,
tanks, regulators, valves, fittings, etc. owned by the gas company.
O.
"Distributing plant" means a
facility with the primary purpose of distribution of LP gas, which receives LP
gas in tank car, truck transport or truck lots, and distributes such LP gas to
end-users by delivery tank truck or through gas piping; such plants have bulk
storage of 2,000 gallons water capacity or more, and usually have
container-filling and truck-loading facilities on the premises.
P.
"Distributing point" means a
facility other than a distributing plant which normally receives gas by tank
truck and which fills small containers or the engine fuel tank of motor
vehicles on the premises. (An LP gas service station is one type of
distributing point).
Q.
"Disqualifying criminal conviction" has the same meaning as
defined in Subsection E of Section
61-1-36 NMSA 1978.
R.
"Division" means the
construction industries division of the regulation and licensing
department.
S.
"Energy
efficient water heater" means any LP gas automatic storage water heater
that meets or exceeds ASHREA 90-75 standards for energy efficiency.
T.
"Fuel gas piping system"
means the arrangement of piping, tubing, fittings, connectors, valves and
devices designed and intended to supply or control the flow of fuel gas to the
appliances.
U.
"Gas
company" means any LP gas company or LP gas distributor.
V.
"Gas supply connection" means
the terminal end or connection to which a gas supply connector is
attached.
W.
"Gas supply
connector" means tubing or piping connecting the mobile home to the gas
supply source.
X.
"Gas
vents" means factory-built vent piping and vent fittings listed by an
approved testing agency, that are assembled and used in accordance with the
terms of their listings, for conveying flue gases to the outside
atmosphere.
Y.
"Heat producing
appliance" means all heating and cooking appliances and all fuel burning
appliances.
Z.
"Heating
appliance" means an appliance for comfort heating or for water heating
of a manufactured home.
AA.
"House piping" means the LP gas piping from the point where it
enters the building or foundation, up to and including the outlets.
BB.
"Input rating" means the LP
gas-burning capacity of an appliance in BTU's per hour as specified by the
manufacturer.
CC.
"Inspector" means a person hired by the bureau to enforce under
administrative direction the laws and safety rules and regulations of the LP
gas industry and the enforcement of the codes used in CNG, LNG and LCNG in
motor vehicles.
DD.
"Labeled" means equipment or materials to which has been attached
a label, symbol or other identifying mark of an organization acceptable to the
"authority having jurisdiction" and concerned with product evaluation that
maintains periodic inspection of production of labeled equipment or materials
and by whose labeling the manufacturer indicate compliance with appropriate
standards or performance in specified manner.
EE.
"Liquefied natural gases",
"liquefied compressed natural gases", "LNG" and "LCNG"
means a fluid in the liquid state composed predominantly of methane and that
can contain minor quantities of ethane, propane, nitrogen, or other components
normally found in natural gas.
FF.
"Liquefied petroleum gases", "LPG" and "LP gas" means
any material that is composed predominantly of any of the following
hydrocarbons or mixtures of them: propane, propylene, butane (normal butane or
ISO-butane) and butylenes.
GG.
"Liquid transfer" means the transfer of LP gas in a liquid form
from an approved container into another approved container.
HH.
"Liquid withdrawal" means an
approved LP gas container designed for the withdrawal of LP gas for utilization
in an approved means.
II.
"Listed" means equipment or materials included in a list published
by an organization acceptable to the authority having jurisdiction and
concerned with product evaluation that maintains periodic inspection of
production of listed equipment or materials and whose listing states either
that the equipment or material meets appropriate standards or has been tested
and found suitable for use in a specified manner.
JJ.
"LP gas installation" means
the installation of materials, fixtures, appliances or equipment that utilize
LP gas, which is installed by a licensee of the LP gas bureau.
KK.
"Manufactured homes" means a
movable or portable housing structure over 32 feet in length or over eight feet
in width constructed to be towed on its own chassis and designed to be
installed with or without a permanent foundation for human occupancy as a
residence and which may include one or more components that can be retracted
for towing purposes and subsequently expanded for additional capacity or may be
two or more units separately towable but designed to be joined into one
integral unit, as well as a single unit. Manufactured homes do not include
recreational vehicles or modular or pre-manufactured homes, built to building
code standards, designed to be permanently affixed to real property.
LL.
"Manufactured home site"
means a designated portion of a mobile home park designed for the accommodation
of one mobile home and its accessory buildings or structures for the exclusive
use of the occupants.
MM.
"Manufactured home park" means a parcel (or contiguous parcels) of
land which has been so designated and improved so that it contains two or more
manufactured home sites available to the general public for the placement
thereon of manufactured homes for occupancy.
NN.
"Military service member"
has the same meaning as defined in Paragraph (3) of Subsection F of Section
61-1-34 NMSA 1978.
OO.
"Outlet" means a threaded
connection or bolted flange in a pipe system to which an LP gas-burning
appliance is or may be attached; such outlet must be located in the room or
space where the appliance is or may be installed.
PP.
"Point of delivery" means
the initial junction of the consumer's gas piping with the gas company's
piping, at the outlet side of the first regulator, regardless of whether it is
a single-stage regulator system or the first stage regulator of a two-stage
regulator system.
QQ.
"Product" or "products" of liquefied petroleum gases,
compressed natural gases or liquefied natural gas are considered to be
liquefied petroleum gases or compressed natural gases or liquefied natural
gases respectively.
RR.
"Qualified instructor" means an employee who has passed the
required examination and performed for at least one year the work being
taught.
SS.
"Readily
accessible" means having direct access without the necessity of removing
any panel, door or similar obstruction.
TT.
"Regulator" means a device
for controlling and maintaining a uniform pressure to the manifold of gas
equipment.
UU.
"Riser"
means that portion of the yardline, which protrudes through the grade level of
the ground.
VV.
"Roof
jack" that portion of venting system, including the cap, insulating
means, flashing and ceiling plate, located in and above the roof.
WW.
"Sealed combustion/direct vent
system appliance", "direct vent system appliance" means an appliance
which by its inherent design is constructed so that all air supplied for
combustion to the combustion system of the appliance, and all products of
combustion are completely isolated from the atmosphere of the space in which it
is installed, and all flue gases are discharged to the outside.
XX.
"Substantially equivalent"
means the determination by the construction industries division that the
education, examination, and experience requirements contained in the statutes
and rules of another jurisdiction are comparable to, or exceed the education,
examination, and experience requirements of the LP & CNG Act.
YY.
"Yardline" means a buried
line servicing utilities from the on-site utility terminal to the manufactured
home.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.