All maps and drawings required by Chapter 1513. of the Revised
Code or Chapters 1501:13-1 to 1501:13-14 of the Administrative Code shall, in
addition to other applicable requirements, be in
quadruplicate and,
be submitted to the
division and, where the area of land to be permitted is ten acres or
less, have a scale of one inch equals one hundred feet; where the area of land
to be permitted is greater than ten acres but less than one hundred acres, have
a scale of one inch equals two hundred feet; and where the area of land to be
permitted is equal to or greater than one hundred acres, have a scale of one
inch equals four hundred feet. All acreage figures required to be reported or
estimated shall be to the nearest one-tenth of an acre. All annual maps,
progress maps and the final map shall be at the same scale as the application
map submitted for the permit.
North shall be toward the top of the map. All maps shall
include the following:
(A) A location
or quadrangle map placed in the upper right corner of the map, with a scale of
one inch equals one mile, which shall depict:
(1) A minimum area of four miles by four
miles;
(2) The site of the area of
land to be permitted;
(3) State,
county, township, and section lines;
(4) Federal, state, county, township, or
other roads;
(5) The north arrow;
and
(6) Name of the quadrangle
map.
(B) A legend placed
to the right side and below the location map. The legend shall indicate which
map symbols from paragraph (C) of rule
1501:13-4-10
of the Administrative Code appear on the map.
(C)
(1) A
notarized map certification by the qualified registered professional surveyor
placed to the right side and below the map legend. The certification shall
read: "I, the undersigned, hereby certify that this map is correct, and shows
to the best of my knowledge and belief all the information required by Chapter
1513. of the Revised Code and rules adopted thereunder."
(2) If the map under paragraph (C)(1) of this
rule has the only depiction of design elements for proposed features, the map
shall also be signed and sealed by the qualified registered professional
engineer who designed those elements. The certification by the engineer shall
read: "I, the undersigned, hereby certify that the design elements are
correctly depicted on this map."
(D) A title block placed in the lower right
corner of the map containing the following information in the order listed:
(1) The title of the map describing whether
it is an application map, supplemental map, hydrologic map, progress map,
annual map, or final map;
(2) The
name of the applicant;
(3) The
township and range designation;
(4)
The name of the township and county;
(5) The sections and/or lot
numbers;
(6) The scale of the
map;
(7) The contour interval of
the map; and
(8) The date the map
was prepared.
Notes
Ohio Admin. Code 1501:13-4-09
Effective:
2/14/2022
Five Year Review (FYR) Dates:
11/30/2021 and
02/14/2027
Promulgated
Under:
119.03
Statutory Authority:
1513.02
Rule Amplifies:
1513.07
Prior Effective Dates: 09/01/1977, 08/28/1978, 05/01/1980,
08/16/1982 (Emer.), 10/27/1982, 10/28/2010,
01/17/2016
