Or. Admin. Code § 340-244-0245 - Gasoline Dispensing Facilities: Work Practices, No Top Off, and Submerged Fill
(1)
Work
Practices. The owner or operator of a GDF must not allow gasoline to be
handled in a manner that would result in vapor releases to the atmosphere for
extended periods of time. Measures to be taken include, but are not limited to,
the following:
(a) Minimize gasoline
spills;
(b)
Do not top
off or overfill vehicle tanks.
(A) If a
person can confirm that a vehicle tank is not full after the nozzle clicks off,
such as by checking the vehicle's fuel tank gauge, the person may continue to
dispense fuel using best judgment and caution to prevent a spill;
(B) Post sign(s) at the GDF instructing a
person filling up a motor vehicle to not top off the vehicle tank. A sign must
be placed on each gasoline dispenser, or on a permanent fixture within six feet
of the dispenser, and be clearly visible to an individual using the hose and
nozzle to dispense gasoline;
(c) Clean up spills as expeditiously as
practicable. The owner or operator must develop a written plan that describes
how a spill will be cleaned up upon occurrence. The plan must include, but is
not limited to, where spill materials are located, a brief description of how
each is used, and an explanation of how the owner or operator is implementing
the 'as expeditiously as practicable' requirement of this subsection
(c).
(d) Cover all open gasoline
containers and all gasoline storage tank fill-pipes with a gasketed seal when
not in use;
(e) Minimize gasoline
sent to open waste collection systems that collect and transport gasoline to
reclamation and recycling devices, such as oil/water separators.
(f) Ensure that cargo tanks unloading
gasoline at the GDF comply with subsections (1)(a) through (d).
(2)
Submerged Fill.
Except for gasoline storage tanks with a capacity of less than 250 gallons, the
owner or operator of a GDF must only load gasoline into storage tanks at the
GDF by utilizing submerged filling, as defined in OAR
340-244-0232, and as specified
in subsection (2)(a), (2)(b), or (2)(c). The applicable distances in
subsections (2)(a) and (2)(b) must be measured from the point in the opening of
the submerged fill pipe that is the greatest distance from the bottom of the
storage tank.
(a) Submerged fill pipes
installed on or before Nov. 9, 2006, must be no more than 12 inches from the
bottom of the storage tank.
(b)
Submerged fill pipes installed after Nov. 9, 2006, must be no more than 6
inches from the bottom of the storage tank.
(c) Submerged fill pipes not meeting the
specifications of subsection (2)(a) or (2)(b) are allowed if the owner or
operator of a GDF can demonstrate that the liquid level in the tank is and
always has been above the entire opening of the fill pipe. Documentation
providing such demonstration must be made available for inspection by DEQ
during the course of a site visit or upon request within 48 hours.
(3)
Cargo Tank
Unloading. Any cargo tank unloading at a GDF that is equipped with a
Stage I vapor balance system or Enhanced Vapor Recovery system must connect to
the system whenever gasoline is being loaded.
(4) Portable gasoline containers that meet
the requirements of 40 C.F.R. part 59 subpart F are considered acceptable for
compliance with subsection (1)(d).
[NOTE: This rule is included in the State of Oregon Clean Air Act Implementation Plan that EQC adopted under OAR 340-200-0040 only for affected sources in the Portland-Vancouver, Medford-Ashland, and Salem-Keizer Area Transportation Study air quality management areas and all of Clackamas, Multnomah, and Washington counties.]
Notes
Statutory/Other Authority: ORS 468.020 & 468A.025
Statutes/Other Implemented: ORS 468A.025
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.