34 Pa. Code § 21.35 - Single or straight ladders
(a)
Single ladders over 30 feet in length shall not be used.
(b) The width between side rails at the base
shall in no case be less than 11 1/2 inches for ladders up to and including 10
feet in length. For longer ladders this width should be increased at least 1/4
inch for each additional foot of length.
(c) Rectangular wood side rails may have an
end depth of not less than 2-1/4 inches and shall have center cross section to
conform with the requirements of §
21.32 (relating to side rails).
Rungs shall conform to the requirements of §
21.33 (relating to
steps).
(d) Hooked tops which fit
over shaftings, roofs and other similar places shall be employed on single
ladders where working conditions warrant.
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.