16 Tex. Admin. Code § 74.76 - Responsibilities of the Inspector - Inspectors Equipment Test Tags
(a) The inspector must purchase test tags
from the department and must be the person who attaches these tags to the
inspected equipment.
(b) The
inspector must inscribe all required information on each department test tag.
Department test tags shall not be replaced until after all date and signature
spaces on the tag are filled.
(c)
Upon completion of the initial acceptance test, department test tags must be
conspicuously attached to each individual piece of equipment on or adjacent to
the equipment controller or main line disconnect.
(d) All devices and adjustments required to
be sealed by the adopted standard must be sealed with wire rope and lead seal
by the inspector witnessing the test(s). There is no need to replace the seal
unless it is broken. If a seal is broken, an inspector must witness the test
and provide a seal as prescribed in this subsection prior to the unit being
returned to service. The lead seal must be crimped onto the wire rope using a
crimping tool bearing the department's seal and the crimping tool number
assigned to the inspector. An inspector may use the required crimping tool to
seal lead seals provided by the manufacturer at the factory as long as the
assigned number is legible.
(e)
Inspector's equipment may be purchased from the department for $200 per 100
test tags (sold in multiples of 100).
(f) The inspector must verify that
contractor's test tags are placed on the equipment in conformance with the
technical requirements adopted in § 74.100.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.