Utah Admin. Code R649-3-10 - Tolerances for Vertical Drilling
1. Deviation from the vertical for short
distances is permitted in the drilling of a well without special approval to
straighten the hole, sidetrack junk, or correct other mechanical
difficulties.
2. Each well shall be
drilled such that the surface location of the well and any points along the
intended well bore shall be within the tolerances allowed by Subsection
R649-3-2, Location and Siting of
Vertical Wells and Statewide Spacing for Horizontal Wells, or the appropriate
board order.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.