40 CFR 60.5175 - How do I establish operating limits if I do not use a wet scrubber, fabric filter, electrostatic precipitator, activated carbon injection, or afterburner, or...limit emissions in some other manner, to comply with the emission limits?
If you use an air pollution control device other than a wet scrubber, fabric filter, electrostatic precipitator, activated carbon injection, or afterburner, or limit emissions in some other manner (e.g., materials balance) to comply with the emission limits in § 60.5165, you must meet the requirements in paragraphs (a) and (b) of this section.
(b) Petition the Administrator for specific operating parameters, operating limits, and averaging periods to be established during the initial performance test and to be monitored continuously thereafter.
(1) You are responsible for submitting any supporting information in a timely manner to enable the Administrator to consider the application prior to the performance test. You must not conduct the initial performance test until after the petition has been approved by the Administrator, and you must comply with the operating limits as written, pending approval by the Administrator. Neither submittal of an application, nor the Administrator's failure to approve or disapprove the application relieves you of the responsibility to comply with any provision of this subpart.
(2) Your petition must include the five items listed in paragraphs (b)(2)(i) through (b)(2)(v) of this section.
(i) Identification of the specific parameters you propose to monitor.
(ii) A discussion of the relationship between these parameters and emissions of regulated pollutants, identifying how emissions of regulated pollutants change with changes in these parameters, and how limits on these parameters will serve to limit emissions of regulated pollutants.
(iii) A discussion of how you will establish the upper and/or lower values for these parameters that will establish the operating limits on these parameters, including a discussion of the averaging periods associated with those parameters for determining compliance.
(iv) A discussion identifying the methods you will use to measure and the instruments you will use to monitor these parameters, as well as the relative accuracy and precision of these methods and instruments.
(v) A discussion identifying the frequency and methods for recalibrating the instruments you will use for monitoring these parameters.
Title 40 published on 2015-08-22
The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 40 CFR Part 60 after this date.
- 40 CFR 60.5170 — What Operating Limits and Requirements Must I Meet and by When?
- 40 CFR 60.5050 — What Authorities Will Not Be Delegated to State, Local, or Tribal Agencies?
- 40 CFR 60.5210 — How Do I Demonstrate Continuous Compliance With My Operating Limits?
- 40 CFR 60.5110 — How Do I Comply With the Increment of Progress for Submittal of a Control Plan?
- 40 CFR 60.5230 — What Records Must I Keep?
- 40 CFR 60.5190 — How Do I Establish My Operating Limits?