40 CFR Appendix Table 2 to Subpart FFFF of Part 60 - Table 2 to Subpart FFFF of Part 60—Model Rule—Emission Limitations

As stated in § 60.3022, you must comply with the following:

For the air pollutant	You must meet this emission limitation a	Using this averaging time	And determining compliance using this method
1. Cadmium	18 micrograms per dry standard cubic meter	3-run average (1 hour minimum sample time per run)	Method 29 of appendix A of this part.
2. Carbon monoxide	40 parts per million by dry volume	3-run average (1 hour minimum sample time per run during performance test), and 12-hour rolling averages measured using CEMS b	Method 10, 10A, or 10B of appendix A of this part and CEMS.
3. Dioxins/furans (total basis)	33 nanograms per dry standard cubic meter	3-run average (1 hour minimum sample time per run)	Method 23 of appendix A of this part.
4. Hydrogen chloride	15 parts per million by dry volume	3-run average (1 hour minimum sample time per run)	Method 26A of appendix A of this part.
5. Lead	226 micrograms per dry standard cubic meter	3-run average (1 hour minimum sample time per run)	Method 29 of appendix A of this part.
6. Mercury	74 micrograms per dry standard cubic meter	3-run average (1 hour minimum sample time per run)	Method 29 of appendix A of this part.
7. Opacity	10 percent	6-minute average (observe over three 1-hour test runs; i.e., thirty 6-minute averages)	Method 9 of appendix A of this part.
8. Oxides of nitrogen	103 parts per million by dry volume	3-run average (1 hour minimum sample time per run)	Method 7, 7A, 7C, 7D, or 7E of appendix A of this part, or ANSI/ASME PTC 19.10–1981 (IBR, see § 60.17(h)) in lieu of Methods 7 and 7C only.
9. Particulate matter	0.013 grains per dry standard cubic foot	3-run average (1 hour minimum sample time per run)	Method 5 or 29 of appendix A of this part.
10. Sulfur dioxide	3.1 parts per million by dry volume	3-run average (1 hour minimum sample time per run)	Method 6 or 6C of appendix A of this part, or ANSI/ASME PTC 19.10–1981 (IBR, see § 60.17(h)) in lieu of Method 6 only.

a All emission limitations (except for opacity) are measured at 7 percent oxygen, dry basis at standard conditions.

b Calculated each hour as the average of the previous 12 operating hours.