40 CFR Appendix Table 2 to Subpart KKKK of Part 63 - Table 2 to Subpart KKKK of Part 63—Emission Limits for Existing Affected Sources

You must comply with the emission limits that apply to your affected source in the following table as required by § 63.3490(a) through (c).

If you apply surface coatings to metal cans or metal can parts in this subcategory ...	Then for all coatings of this type ...	You must meet the following organic HAP emission limit in kg HAP/liter solids (lbs HAP/gal solids): a b
1. One and two-piece draw and iron can body coating	a. Two-piece beverage cans—all coatings b. Two-piece food cans—all coatings c. One-piece aerosol cans—all coatings	0.07 (0.59). 0.06 (0.51). 0.12 (0.99).
2. Sheetcoating	Sheetcoating	0.03 (0.26).
3. Three-piece can assembly	a. Inside spray	0.29 (2.43).
	b. Aseptic side seam stripes on food cans	1.94 (16.16).
	c. Nonaseptic side seam stripes on food cans	0.79 (6.57).
	d. Side seam stripes on general line nonfood cans	1.18 (9.84).
	e. Side seam stripes on aerosol cans	1.46 (12.14).
4. End coating	a. Aseptic end seal compounds	0.06 (0.54).
	b. Nonaseptic end seal compounds	0.00 (0.00).
	c. Repair spray coatings	2.06 (17.17).

a If you apply surface coatings of more than one type within any one subcategory you may calculate an OSEL according to § 63.3531(i).

b Rounding differences in specific emission limits are attributable to unit conversions.