47 CFR 15.111 - Antenna power conduction limits for receivers.

§ 15.111 Antenna power conduction limits for receivers.

(a) In addition to the radiated emission limits, receivers that operate (tune) in the frequency range 30 to 960 MHz and CB receivers that provide terminals for the connection of an external receiving antenna may be tested to demonstrate compliance with the provisions of § 15.109 with the antenna terminals shielded and terminated with a resistive termination equal to the impedance specified for the antenna, provided these receivers also comply with the following: With the receiver antenna terminal connected to a resistive termination equal to the impedance specified or employed for the antenna, the power at the antenna terminal at any frequency within the range of measurements specified in § 15.33 shall not exceed 2.0 nanowatts.

(b) CB receivers and receivers that operate (tune) in the frequency range 30 to 960 MHz that are provided only with a permanently attached antenna shall comply with the radiated emission limitations in this part, as measured with the antenna attached.

Title 47 published on 09-May-2017 04:29

The following are ALL rules, proposed rules, and notices (chronologically) published in the Federal Register relating to 47 CFR Part 15 after this date.

  • 2017-05-10; vol. 82 # 89 - Wednesday, May 10, 2017
    1. 82 FR 21780 - FCC Seeks Comment and Data on Actions To Accelerate Adoption and Accessibility of Broadband-Enabled Health Care Solutions and Advanced Technologies
      GPO FDSys XML | Text
      FEDERAL COMMUNICATIONS COMMISSION
      Request for comments.
      Submit comments on or before May 24, 2017, and reply comments on or before June 8, 2017.
      47 CFR 1, 15, 20, and 54

Pages

The section you are viewing is cited by the following CFR sections.