Fla. Admin. Code Ann. R. 62-296.502 - Coil Coating
(1)
Applicability. The emission limiting standard set forth in Rule
62-296.502, F.A.C., will apply
to coating applicators, coating lines with or without ovens, and quench areas
of coil coating lines involved in prime and topcoat or single-coat
operations.
(2) Emission Limiting
Standard. No owner or operator of a coil coating line subject to Rule
62-296.502, F.A.C., may cause,
allow, or permit the discharge into the atmosphere of any volatile organic
compounds in excess of 2.6 pounds per gallon of coating (0.31 kilograms per
liter), excluding water delivered to a coating applicator from prime and
topcoat or single-coat operations.
(3) Control Technology. The emission limit
under subsection 62-296.502(2),
F.A.C., shall be achieved by:
(a) The
application of low solvent content coating technology, or
(b) Incineration, provided that 90 percent of
the volatile organic compounds (VOC measured as a total combustible carbon)
which enter the incinerator are oxidized to carbon dioxide and
water.
(4) Test Methods
and Procedures. All emissions tests performed pursuant to the requirements of
this rule shall comply with the following requirements.
(a) Low Solvent Technology. The test method
for volatile organic compounds shall be EPA Method 24, as described at 40
C.F.R. Part 60, Appendix A-7, adopted and incorporated by reference at Rule
62-204.800, F.A.C., or EPA
450/3-84-019, Procedures for Certifying Quantity of Volatile Organic Compounds
Emitted by Paint, Ink, and Other Coatings (http://www.flrules.org/Gateway/reference.asp?No=Ref-04298),
hereby adopted and incorporated by reference.
(b) Add-on Control Device.
1. Destructive. The test method for volatile
organic compounds shall be EPA Method 25, as described at 40 C.F.R. Part 60,
Appendix A-7, adopted and incorporated by reference at Rule
62-204.800, F.A.C., or
Attachment 3 of EPA 450/2-78-041, Alternate Test Method for Direct Measurement
of Total Gaseous Organic Compounds Using a Flame Ionization Analyszer, adopted
and incorporated by reference in Chapter 62-297, F.A.C.
2. Non-destructive. The test method for
volatile organic compounds shall be VOC Capture Efficiency Test Procedures as
described in Rule 62-297.450, F.A.C. The sampling
time for each capture efficiency test run shall be at least 8 hours, unless
otherwise approved by the Department pursuant to Rule
62-297.620,
F.A.C.
(c) Test
procedures shall meet all applicable requirements of Chapter 62-297,
F.A.C.
Notes
Rulemaking Authority 403.061 FS. Law Implemented 403.021, 403.031, 403.061, 403.087 FS.
Formerly 17-2.650(1)(f)2., 17-296.502, Amended 11-23-94, 1-1-96, 7-10-14.
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.