(1) Applicability.
(a) The emission limiting standards set forth
in Rule
62-296.506, F.A.C., shall apply
to application areas, flash-off areas, and ovens of large appliance coating
lines involved in prime, single, or topcoat coating operations. Credit for
transfer efficiency above the baseline of 60% for spray coating operations can
be granted according to the following formula:
X = (te) (z) (y)
____________
Y + (TE) (Z)
where
X = allowable maximum VOC content (kg VOC/liter of coating
less
water)
Y = density of the VOC in the maximum VOC content
coating
(kg/liter)
Z = applicable emission limit (kg VOC/liter of coating
solids
deposited)
TE = transfer efficiency
An EPA and state approved test method for determination of
transfer efficiency above the baseline is required.
(b) Rule
62-296.506, F.A.C., does not
apply to the use of quick-drying lacquers for repair of scratches and nicks
that occur during assembly, provided that the volume of coating does not exceed
one quart (0.95 liters) in any one 8-hour period.
(2) Emission Limiting Standard. No owner or
operator of a large appliance coating line subject to Rule
62-296.506, F.A.C., may cause,
allow or permit the discharge into the atmosphere of any volatile organic
compounds in excess of 0.34 kilograms per liter of coating (2.8 pounds per
gallon), excluding water, delivered to the coating applicator from prime,
single, or topcoat coating operations.
(3) Control Technology. The emission limit
under subsection
62-296.506(2),
F.A.C., shall be achieved by:
(a) The
application of low solvent content coating technology, or
(b) Incineration, provided that 90 percent of
the volatile organic compounds (VOC measured as total combustible carbon) which
enter the incinerator are oxidized to carbon dioxide and
water.
(4) Test Methods
and Procedures. All emissions tests performed pursuant to the requirements of
this rule shall comply with the following requirements.
(a) Low Solvent Technology. The test method
for volatile organic compounds shall be EPA Method 24, as described at 40
C.F.R. Part
60, Appendix A-7, adopted and incorporated by reference at Rule
62-204.800, F.A.C., or EPA
450/3-84-019, Procedures for Certifying Quantity of Volatile Organic Compounds
Emitted by Paint, Ink, and Other Coatings (
http://www.flrules.org/Gateway/reference.asp?No=Ref-04298),
hereby adopted and incorporated by reference.
(b) Add-on Control Device.
1. Destructive. The test method for volatile
organic compounds shall be EPA Method 25, as described at 40 C.F.R. Part
60,
Appendix A-7, adopted and incorporated by reference at Rule
62-204.800, F.A.C., or
Attachment 3 of EPA 450/2-78-041, Alternate Test Method for Direct Measurement
of Total Gaseous Organic Compounds Using a Flame Ionization Analyzer, adopted
and incorporated by reference in Chapter 62-297, F.A.C.
2. Non-destructive. The test method for
volatile organic compounds shall be VOC Capture Efficiency Test Procedures as
described at Rule
62-297.450, F.A.C. The sampling
time for each capture efficiency test run shall be at least 8 hours, unless
otherwise approved by the Department pursuant to Rule
62-297.620,
F.A.C.
(c) Test
procedures shall meet all applicable requirements of Chapter 62-297,
F.A.C.
Notes
Fla. Admin.
Code Ann. R. 62-296.506
Rulemaking Authority 403.061 FS. Law Implemented 403.021,
403.031, 403.061, 403.087 FS.
Formerly 17-2.650(1)(f)
6., 17-296.506, Amended 11-23-94, 1-1-96, Amended by
Florida
Register Volume 40, Number 122, June 24, 2014 effective
7/10/2014.
Formerly 17-2.650(1)(f)6., 17-296.506, Amended 11-23-94,
1-1-96, 7-10-14.
