(These standards may also apply as ground water quality
standards as referenced in Chapter 62-520, F.A.C.)
(1) Inorganics - Except for nitrate and
nitrite, which apply to all public water systems, this subsection applies to
community water systems and non-transient non-community water systems only.
(a) The maximum contaminant levels for the
inorganic contaminants are listed in Table 1, which is incorporated herein and
appears at the end of this chapter.
(b) The
maximum contaminant level for nitrate
(as N) applicable to transient non-community water systems is 10 milligrams per
liter. The
Department or
Approved County Health Department shall allow a
contaminant level for nitrate (as N) of up to 20 milligrams per liter upon a
showing by the
supplier of water that the following conditions are met:
1. The water distributed by the water system
is not available to children under 6 months of age or to lactating mothers,
and
2. There is continuous public
notification of what the nitrate level (as N) is and what the potential health
effects of such exposure are.
3.
The Department shall require monitoring every 3 months as long as the maximum
contaminant level is exceeded. Should adverse health effects occur, the
Department shall require immediate compliance with the maximum contaminant
level for nitrate (as N).
(c) The revised maximum contaminant level of
0.010 mg/L for arsenic becomes effective January 1, 2005. All community and
non-transient non-community water systems shall demonstrate compliance with the
revised maximum contaminant level by December 31, 2007.
(2) Disinfectant Residuals.
(a) Maximum residual
disinfectant levels
(MRDLs) are as follows:
DISINFECTANT RESIDUAL
|
MRDL
|
Chlorine
|
4.0 mg/L (as Cl2)
|
Chloramines
|
4.0 mg/L (as Cl2).
|
Chlorine Dioxide
|
0.8 mg/L (as ClO2).
|
(40 C.F.R.
§
141.65(a) (July 1,
2011))
(b) Compliance dates
- community water systems and non-transient non-community water systems.
(40 C.F.R. §
141.65(b) (July 1, 2011))
1. Subpart H systems serving 10, 000 or more
persons must comply with paragraph (a) above beginning January 1, 2002. Subpart
H systems serving fewer than 10, 000 persons and systems using only ground
water not under the direct influence of
surface water must comply with
paragraph (a) above beginning January 1, 2004. (40 C.F.R. §
141.65(b)(1) (July 1,
2011))
2. If you are a
consecutive
system that does not add a
disinfectant but delivers water that has been
treated with a primary or residual
disinfectant other than ultraviolet light,
you must comply with analytical and monitoring requirements for chlorine and
chloramines in 40 C.F.R.
§
141.131(c) and §
141.132(c)(1)
(which are incorporated by reference in subsection
62-550.550(1),
F.A.C., and Rule
62-550.821, F.A.C.) and the
compliance requirements in 40 C.F.R. §
141.133(c)(1) (which is
incorporated by reference in Rule
62-550.821, F.A.C.) beginning April 1, 2009,
and report monitoring results under
40 C.F.R. §
141.134(c) (which is
incorporated by reference in Rule
62-550.821, F.A.C.). (40 C.F.R. §
141.624 (July 1, 2011))
(c) Compliance dates - transient
non-community water systems. Subpart H systems serving 10, 000 or more persons
and using chlorine dioxide as a
disinfectant or oxidant must comply with the
chlorine dioxide MRDL beginning January 1, 2002. Subpart H systems serving
fewer than 10, 000 persons and using chlorine dioxide as a
disinfectant or
oxidant and systems using only ground water not under the direct influence of
surface water and using chlorine dioxide as a
disinfectant or oxidant must
comply with the chlorine dioxide MRDL beginning January 1, 2004. (40 C.F.R. §
141.65(b)(2) (July 1,
2011))
(4) Organics - This subsection applies only
to community water systems and non-transient non-community water systems.
(a) The maximum contaminant levels for the
volatile organic contaminants (VOCs) are listed in Table 4, which is
incorporated herein and appears at the end of this chapter. The regulatory
detection limit (RDL) for all VOCs is 0.0005 mg/L.
(b) The maximum contaminant levels and the
regulatory detection limits (RDLs) for the synthetic organic contaminants
(SOCs) are listed in Table 5, which is incorporated herein and appears at the
end of this chapter.
(5)
Microbiological - This subsection applies to all public water systems. Until
March 31, 2016, monitoring requirements to demonstrate compliance with this
subsection are defined in Rule
62-550.518, F.A.C. Beginning
April 1, 2016, monitoring requirements to demonstrate compliance with this
subsection are defined in Rule
62-550.830, F.A.C. This
subsection shall be effective on July 7, 2015.
(a) Until March 31, 2016, the total coliform
MCL is based on the presence or absence of total coliforms in a sample, rather
than coliform density. (40
C.F.R. §
141.63(b)
revised as of July 1, 2014.) For the purpose of the public notice requirements
in Rule
62-560.410, F.A.C., a violation
of the standards in this paragraph poses a non-acute risk to health. This
paragraph shall be effective on July 7, 2015.
1. For a system which collects at least 40
samples per month, if no more than 5.0 percent of the samples collected during
a month are total coliform-positive, the system is in compliance with the
maximum contaminant level for total coliforms.
2. For a system which collects fewer than 40
samples per month, if no more than one sample collected during a month is total
coliform-positive, the system is in compliance with the maximum contaminant
level for total coliforms.
(b) Until March 31, 2016, any fecal
coliform-positive repeat sample or
E. coli-positive repeat
sample, or any total coliform-positive repeat sample following a fecal
coliform-positive or
E. coli-positive routine sample is a
violation of the MCL for total coliforms. For the purposes of the public
notification requirements in Rule
62-560.410, F.A.C., this is a violation that
poses an acute risk to health. (40 C.F.R. §
141.63(b) revised as of July
1, 2014.) This paragraph shall be effective on July 7, 2015.
(c) Until March 31, 2016, a
public water
system shall determine compliance with the MCL for total coliforms in
paragraphs (a) and (b) of this subsection for each month in which it is
required to monitor for total coliforms. (40 C.F.R. §
141.63(d) revised as of July
1, 2014.) This paragraph shall be effective on July 7, 2015.
(d) Beginning April 1, 2016, a system is in
compliance with the MCL for
E. coli for samples taken under
the provisions of 40 C.F.R. Part
141, Subpart Y, which is incorporated by
reference in Rule 62.550.830, F.A.C., unless any of the conditions identified
in the following subparagraphs 1. through 4. occur. For purposes of the public
notification requirements in 40 C.F.R. Part
141, Subpart Q, which is
incorporated by reference in Rule
62-560.410, F.A.C., violation of the MCL may
pose an acute risk to health. (40 C.F.R. §
141.63(c) revised as of July
1, 2014.) This paragraph shall be effective on July 7, 2015.
1. The system has an
E.
coli-positive repeat sample following a total coliform-positive
routine sample. (40 C.F.R.
§
141.63(c)(1) revised
as of July 1, 2014.) This subparagraph shall be effective on July 7,
2015.
2. The system has a total
coliform-positive repeat sample following an
E. coli-positive
routine sample. (40 C.F.R.
§
141.63(c)(2) revised
as of July 1, 2014.) This subparagraph shall be effective on July 7,
2015.
3. The system fails to take
all required repeat samples following an
E. coli-positive
routine sample. (40 C.F.R.
§
141.63(c)(3) revised
as of July 1, 2014.) This subparagraph shall be effective on July 7,
2015.
4. The system fails to test
for
E. coli when any repeat sample tests positive for total
coliform. (40 C.F.R. §
141.63(c)(4) revised as of
July 1, 2014.) This subparagraph shall be effective on July 7,
2015.
(e) Beginning April
1, 2016, a
public water system must determine compliance with the MCL for
E. coli in paragraph
62-550.310(5)(d),
F.A.C., for each month in which it is required to monitor for total coliforms.
(40 C.F.R. §
141.63(d) revised as of July
1, 2014.) This paragraph shall be effective on July 7,
2015.
(6) Radionuclides -
This subsection applies to community and nontransient noncommunity water
systems. The following are the maximum
contaminant levels (MCLs) and regulatory
detection limits (RDLs) for radionuclides:
(a)
Naturally occurring radionuclides:
MAXIMUM CONTAMINANT LEVELS FOR RADIONUCLIDES
CONTAMINANT
|
MAXIMUM CONTAMINANT LEVEL
|
Combined radium226 and radium228
|
5 pCi/L
|
Gross alpha particle activity including radium226 but
excluding radon and uranium
|
15 pCi/L
|
Uranium
|
30 ug/L
|
pCi/L = picoCuries per liter
ug/L = micrograms per liter
(b) Man-made radionuclides:
1. The average annual concentration of beta
particle and photon radioactivity from man-made radionuclides in drinking water
shall not produce an annual dose equivalent to the body or any internal organ
greater than 4 millirem/year.
2.
Except for those radionuclides listed below, the concentration of man-made
radionuclides causing 4 mrem total body or organ dose equivalents shall be
calculated on the basis of a 2 liter per day drinking water intake using the
168-hour data list in "Maximum Permissible Body Burdens and Maximum Permissible
Concentration of Radionuclides in Air or Water for Occupational Exposure, " NBS
Handbook 69 as amended August 1963, U. S.
Department of Commerce at
http://www.flrules.org/Gateway/reference.asp?No=Ref-04137,
which is incorporated herein by reference.
Average Annual Concentration Assumed to Produce
an Exposure of 4 millirem/year:
RADIONUCLIDE
|
CRITICAL ORGAN
|
pCi/L
|
Tritium
|
total body
|
20, 000
|
Strontium90
|
bone marrow
|
8
|
pCi/L = picoCuries per liter
3. If two or more radionuclides are present,
the sum of their annual dose equivalent to the total body or to any organ shall
not exceed 4 millirem/year.
(c) For the purposes of monitoring for
gross
alpha particle activity, radium-226, radium-228, uranium, and beta particle and
photon radioactivity in drinking water, the following regulatory detection
limits shall be used:
CONTAMINANT
|
REGULATORY DETECTION LIMIT
|
Gross alpha particle activity
|
3 pCi/L
|
Radium-226
|
1 pCi/L
|
Radium-228
|
1 pCi/L
|
Uranium
|
1 ug/L
|
Tritium
|
1, 000 pCi/L
|
Strontium-89
|
10 pCi/L
|
Strontium-90
|
2 pCi/L
|
Iodine-131
|
1 pCi/L
|
Cesium-134
|
10 pCi/L
|
Gross beta
|
4 pCi/L
|
Other radionuclides
|
1/10 of the applicable limit
|
pCi/L = picoCuries per liter
ug/L = micrograms per
liter