49 CFR 173.21 - Forbidden materials and packages.
Unless otherwise provided in this subchapter, the offering for transportation or transportation of the following is forbidden:
(a) Materials that are designated “Forbidden” in Column 3 of the § 172.101 table.
(c) Electrical devices, such as batteries and battery-powered devices, which are likely to create sparks or generate a dangerous evolution of heat, unless packaged in a manner which precludes such an occurrence.
(e) A material in the same packaging, freight container, or overpack with another material, the mixing of which is likely to cause a dangerous evolution of heat, or flammable or poisonous gases or vapors, or to produce corrosive materials.
(f) A package containing a material which is likely to decompose with a self-accelerated decomposition temperature (SADT) or polymerize with a self-accelerated polymerization temperature (SAPT) of 50 °C (122 °F) or less, with an evolution of a dangerous quantity of heat or gas when decomposing or polymerizing, unless the material is stabilized or inhibited in a manner to preclude such evolution. The SADT and SAPT may be determined by any of the test methods described in Part II of the UN Manual of Tests and Criteria (IBR, see § 171.7 of this subchapter).
(1) A package meeting the criteria of paragraph (f) of this section may be required to be shipped under controlled temperature conditions. The control temperature and emergency temperature for a package shall be as specified in the table in this paragraph (f)(1) based upon the SADT or SAPT of the material. The control temperature is the temperature above which a package of the material may not be offered for transportation or transported. The emergency temperature is the temperature at which, due to imminent danger, emergency measures must be initiated.
§ 173.21 Table - Derivation of Control and Emergency Temperature
|SADT/SAPT 1||Control temperatures||Emergency temperature|
|SADT/SAPT ≤20 °C (68 °F)||20 °C (36 °F) below SADT/SAPT||10 °C (18 °F) below SADT/SAPT.|
|20 °C (68 °F) SADT/SAPT ≤35 °C (95 °F)||15 °C (27 °F) below SADT/SAPT||10 °C (18 °F) below SADT/SAPT.|
|35 °C (95 °F) SADT/SAPT ≤50 °C (122 °F)||10 °C (18 °F) below SADT/SAPT||5 °C (9 °F) below SADT/SAPT.|
|50 °C (122 °F) SADT/SAPT||( 2)||( 2)|
1 Self-accelerating decomposition temperature or Self-accelerating polymerization temperature.
2 Temperature control not required.
(i) The provisions concerning polymerizing substances in paragraph (f) will be effective until January 2, 2019.
(2) For self-reactive materials listed in § 173.224(b) table control and emergency temperatures, where required are shown in Columns 5 and 6, respectively. For organic peroxides listed in The Organic Peroxides Table in § 173.225 control and emergency temperatures, where required, are shown in Columns 7a and 7b, respectively.
(3) Refrigeration may be used as a means of stabilization only when approved by the Associate Administrator. Approvals issued by the Bureau of Explosives are no longer valid (see § 171.19 of this subchapter). Methods of stabilization approved by the Associate Administrator are as follows:
(i) For highway transportation:
(A) A material meeting the criteria of this paragraph (f) may be transported only in a transport vehicle, freight container, or motor vehicle equipped with a mechanical refrigeration unit, or loaded with a consumable refrigerant, capable of maintaining the inside temperature of the hazardous material at or below the control temperature required for the material during transportation.
(B) Each package containing a material meeting the criteria of this paragraph (f) must be loaded and maintained at or below the control temperature required for the material. The temperature of the material must be determined by appropriate means and entered on a written record at the time the packaging is loaded.
(C) The vehicle operator shall monitor the inside temperature of the transport vehicle, freight container, or motor vehicle and enter that temperature on a written record at the time the package is loaded and thereafter at intervals not exceeding two hours. Alternatively, a transport vehicle, freight container, or motor vehicle may be equipped with a visible or audible warning device that activates when the inside temperature of the transport vehicle, freight container, or motor vehicle exceeds the control temperature required for the material. The warning device must be readily visible or audible, as appropriate, from the vehicle operator's seat in the vehicle.
(D) The carrier shall advise the vehicle operator of the emergency temperature for the material, and provide the vehicle operator with written procedures that must be followed to assure maintenance of the control temperature inside the transport vehicle, freight container, or motor vehicle. The written procedures must include instructions for the vehicle operator on actions to take if the inside temperature exceeds the control temperature and approaches or reaches the emergency temperature for the material. In addition, the written temperature-control procedures must identify enroute points where the consumable refrigerant may be procured, or where repairs to, or replacement of, the mechanical refrigeration unit may be accomplished.
(E) The vehicle operator shall maintain the written temperature-control procedures, and the written record of temperature measurements specified in paragraph (f)(3)(i)(C) of this section, if applicable, in the same manner as specified in § 177.817 of this subchapter for shipping papers.
(F) If the control temperature is maintained by use of a consumable refrigerant (e.g., dry ice or liquid nitrogen), the quantity of consumable refrigerant must be sufficient to maintain the control temperature for twice the average transit time under normal conditions of transportation.
(G) A material that has a control temperature of 40 °C (104 °F) or higher may be transported by common carrier. A material that has a control temperature below 40 °C (104 °F) must be transported by a private or contract carrier.
(1) For purposes of this paragraph, “detonate” means an explosion in which the shock wave travels through the material at a speed greater than the speed of sound.
(i) Except for a package containing a lighter design sample that meets the requirements of § 173.308(b)(2), a package containing a lighter (see § 171.8 of this subchapter) containing a Division 2.1 material, of a design that has not been examined and successfully tested by an authorized person under the criteria specified in § 173.308(a)(4) or, a lighter design containing a Class 3 material, that has not been approved by the Associate Administrator.
(j) An organic peroxide of the “ketone peroxide” category which contains more than 9 percent available oxygen as calculated using the equation in § 173.128(a)(4)(ii). The category, ketone peroxide, includes, but is not limited to:
(k) Notwithstanding any other provision of this subchapter, including subpart C of part 171 and 175.10(a)(2) of this subchapter, an oxygen generator (chemical) as cargo on a passenger-carrying aircraft. This prohibition does not apply to an oxygen generator for medical or personal use of a passenger that meets the requirements of § 175.10(a)(7) of this subchapter.
- 49 CFR 173.12 — Exceptions for Shipment of Waste Materials.
- 49 CFR 175.10 — Exceptions for Passengers, Crewmembers, and Air Operators.
- 49 CFR 173.220 — Internal Combustion Engines, Vehicles, Machinery Containing Internal Combustion Engines, Battery-Powered Equipment or Machinery, Fuel Cell-Powered Equipment or Machinery.
- 49 CFR 173.4 — Small Quantities for Highway and Rail.
- 49 CFR 171.22 — Authorization and Conditions for the Use of International Standards and Regulations.
- 49 CFR 173.4a — Excepted Quantities.
- 49 CFR 173.33 — Hazardous Materials in Cargo Tank Motor Vehicles.
- 49 CFR 173.21 — Forbidden Materials and Packages.
- 49 CFR 173.225 — Packaging Requirements and Other Provisions for Organic Peroxides.
- 49 CFR 173.4b — De Minimis Exceptions.
- 49 CFR 172.102 — Special Provisions.
- 49 CFR 174.61 — Transport Vehicles and Freight Containers on Flat Cars.
- 49 CFR 173.25 — Authorized Packagings and Overpacks.
- 49 CFR 173.128 — Class 5, Division 5.2 - Definitions and Types.
- 49 CFR 173.224 — Packaging and Control and Emergency Temperatures for Self-Reactive Materials.
- 49 CFR 173.124 — Class 4, Divisions 4.1, 4.2 and 4.3 - Definitions.
- 49 CFR 171.8 — Definitions and Abbreviations.
- 49 CFR 172.101 — Purpose and Use of Hazardous Materials Table.
- 49 CFR 173.36 — Hazardous Materials in Large Packagings.