Utah Admin. Code R315-270-27 - Hazardous Waste Permit Program - Specific Part B Information Requirements for Air Emission Controls for Tanks, Surface Impoundments, and Containers
(a) Except as
otherwise provided in Section
R315-264-1,
owners and operators of tanks, surface impoundments, or containers that use air
emission controls in accordance with the requirements of Sections
R315-264-1080
through 1090, shall provide the following additional information:
(1) Documentation for each floating roof
cover installed on a tank subject to Subsection
R315-264-1084(d)(1) or
(d)(2) that includes information prepared by
the owner or operator or provided by the cover manufacturer or vendor
describing the cover design, and certification by the owner or operator that
the cover meets the applicable design specifications as listed in Subsection
R315-264-1084(e)(1) or
(f)(1).
(2) Identification of each container area
subject to the requirements of Sections
R315-264-1080
through 1090 and certification by the owner or operator that the requirements
of Sections
R315-270-10
through 29 are met.
(3)
Documentation for each enclosure used to control air pollutant emissions from
tanks or containers in accordance with the requirements of Subsection
R315-264-1084(d)(5)
or 1086(e)(1)(ii) that includes records for the most recent set of calculations
and measurements performed by the owner or operator to verify that the
enclosure meets the criteria of a permanent total enclosure as specified in
"Procedure T-Criteria for and Verification of a Permanent or Temporary Total
Enclosure" under
40
CFR 52.741, appendix B.
(4) Documentation for each floating membrane
cover installed on a surface impoundment in accordance with the requirements of
Subsection
R315-264-1085(c)
that includes information prepared by the owner or operator or provided by the
cover manufacturer or vendor describing the cover design, and certification by
the owner or operator that the cover meets the specifications listed in
Subsection
R315-264-1085(c)(1).
(5) Documentation for each closed-vent system
and control device installed in accordance with the requirements of Section
R315-264-1087
that includes design and performance information as specified in Subsections
R315-270-24(c)
and (d).
(6) An emission monitoring plan for both
Method 21 in 40 CFR part 60, appendix A and control device monitoring methods.
This plan shall include the following information: monitoring point(s),
monitoring methods for control devices, monitoring frequency, procedures for
documenting exceedances, and procedures for mitigating
noncompliances.
(7) When an owner
or operator of a facility subject to
40 CFR
265.1080 through 1090, which are adopted by
reference, cannot comply with Sections
R315-264-1080
through 1090 by the date of permit issuance, the schedule of implementation
required under
40
CFR 265.1082, which is adopted by
reference.
Notes
State regulations are updated quarterly; we currently have two versions available. Below is a comparison between our most recent version and the prior quarterly release. More comparison features will be added as we have more versions to compare.
No prior version found.